louis.j
louis.j
Group: Registered
Joined: 2017/01/11
Trusted Member
3
I used the stick on sheets for over a year and they work but...

In forum General discussion, announcements and releases

7 months ago
I use the powder-coated sheets and do not have a problem. I ...

In forum General discussion, announcements and releases

7 months ago
To my eye, it looks like intermittent and very cycle decreas...

In forum General discussion, announcements and releases

7 months ago
MK2.5S filament sensor not working

In forum Hardware, firmware and software help

7 months ago
thank you, I now have the information I need. I find that I...

In forum General discussion, announcements and releases

7 months ago
@neophyl thanks, I looked everywhere on Google for the past ...

In forum General discussion, announcements and releases

7 months ago
@vintagepc sorry, I should have stated my question different...

In forum General discussion, announcements and releases

7 months ago
MK3 vs. MK2.5 hotend heater element

In forum General discussion, announcements and releases

7 months ago
@joantabb are the heaters for the MK3 and MK2 the same? I kn...

In forum Hardware, firmware and software help

7 months ago
If there is no choice - use glue, but if the supports are sm...

In forum General discussion, announcements and releases

7 months ago
@frank-p8 What I see looks like an pencil angled on a paper,...

In forum General discussion, announcements and releases

9 months ago
I think your X-axis carriage or your nozzle is loose. Grab y...

In forum General discussion, announcements and releases

9 months ago
been there, I think you have a leak in the heat break. This ...

In forum General discussion, announcements and releases

10 months ago
You have 2 choices 1. Turn off auto load 2 upgrade to mk3s

In forum General discussion, announcements and releases

10 months ago
@guy-k2 Agree, about half of my eSun filament is damp on arr...

In forum General discussion, announcements and releases

1 year ago
Your filament has become damp, I know because I developed th...

In forum General discussion, announcements and releases

1 year ago
What prusa version are you using ? MK3 MK3S? you need to use...

In forum General discussion, announcements and releases

1 year ago
On my MK3S I do not have a problem, but on my MK2.5S I get t...

In forum General discussion, announcements and releases

1 year ago
any conclusions so far?

In forum General discussion, announcements and releases

1 year ago
I just now started to print your parts. I am doing everythin...

In forum General discussion, announcements and releases

1 year ago
Page 2 / 3
Share:

Please Login or Register