louis.j
louis.j
Group: Registered
Joined: 2017/01/11
Trusted Member
3
I had a similar problem. Much frustration. Removing the sens...

In forum General discussion, announcements and releases

7 days ago
@joantabb Joan - I like your posts and always find them help...

In forum Hardware, firmware and software help

2 weeks ago
I use a toothbrush. You can get them in various stiffness an...

In forum Hardware, firmware and software help

3 months ago
I am using the MK2.5S - it has the steel ball and the 'sens...

In forum Hardware, firmware and software help

3 months ago
Because of the suggestions made here I bought some Atomic bl...

In forum General discussion, announcements and releases

3 months ago
I finally got it to work. I used some compressed air to blow...

In forum Hardware, firmware and software help

3 months ago
@benjamin-r8 I also do not like supports and try to not use ...

In forum General discussion, announcements and releases

4 months ago
@parallax I have used a lot of eSun and it is good except fo...

In forum General discussion, announcements and releases

4 months ago
@chocki please post your stringing test

In forum General discussion, announcements and releases

5 months ago
@covertpluto3502 That worked great! No revisions needed for ...

In forum General discussion, announcements and releases

5 months ago
@covertpluto OK, I found the place. I have a MK2.5S - do I j...

In forum General discussion, announcements and releases

5 months ago
this looks interesting, how do you put in this code?

In forum General discussion, announcements and releases

5 months ago
I have had the same problem. I have the smooth and the textu...

In forum General discussion, announcements and releases

5 months ago
I have a toothbrush. This is used to wipe the nozzle and to ...

In forum General discussion, announcements and releases

5 months ago
I have this also. I think it is not a 'stain' but microfract...

In forum General discussion, announcements and releases

6 months ago
My heat bed thermister broke about 6 months ago on my MK3S a...

In forum General discussion, announcements and releases

6 months ago
I have the same problem. I find it depends on how the filame...

In forum General discussion, announcements and releases

6 months ago
I need a code to park the extruder for cleaning

In forum General discussion, announcements and releases

7 months ago
@chris-m73 This is the first I have seen anyone mention the ...

In forum General discussion, announcements and releases

7 months ago
I have the same problem with both my MK3S and MK2.5S It is r...

In forum General discussion, announcements and releases

7 months ago
Page 1 / 3
Share:

Please Login or Register