Activity
 
lee.o
lee.o
Group: Registered
Joined: 2018/08/19
Trusted Member
3
Thank you for all your help in diagnosing this mysterious pr...

In forum Hardware, firmware and software help

2 years ago
I'd have to get really picky to complain about that result.....

In forum Hardware, firmware and software help

2 years ago
I'm dreadfully confused. You're saying the build-plate is s...

In forum Hardware, firmware and software help

2 years ago
Something to check, are the screw-heads for the bed below th...

In forum Hardware, firmware and software help

2 years ago
Newest kits have a printed insert in the connector to assist...

In forum Assembly and first prints troubleshooting

2 years ago
If they’re both running the same firmware they should rotate...

In forum Hardware, firmware and software help

2 years ago
Dumb question, you did install the MK2.5 firmware, and made ...

In forum Assembly and first prints troubleshooting

2 years ago
Dang, sorry that long print failed. Things that would cause...

In forum Hardware, firmware and software help

2 years ago
I have had both thermisters fail. My search of the forum ma...

In forum Hardware, firmware and software help

2 years ago
Yeah that’s exactly what i wanted to do after I have y-rod h...

In forum Hardware, firmware and software help

2 years ago
A bit of nuisance to remove and reinsert the fialament buts ...

In forum How do I print this? (Printing help)

2 years ago
Hi Lee O Yes, its x-axis. The clicking sounds only happen...

In forum Hardware, firmware and software help

2 years ago
I asked for a "first layer cal" run to gauge the meander tha...

In forum Hardware, firmware and software help

2 years ago
It sounds like you *might* be getting a crash...check your f...

In forum How do I print this? (Printing help)

2 years ago
From what I can tell of your first layer cal result in the l...

In forum Hardware, firmware and software help

2 years ago
Your Y Axis pulley is spinning on its shaft. As soon as it ...

In forum Assembly and first prints troubleshooting

2 years ago
The *official* method for rejuvenating the PEI build surface...

In forum How do I print this? (Printing help)

2 years ago
Thanks! Just seeing this reply. I posted another question ab...

In forum Assembly and first prints troubleshooting

2 years ago
It's not conventional CAD, but it's one of the only truly "o...

In forum General discussion, announcements and releases

2 years ago
You should be able to simply insert an M600 between the comm...

In forum How do I print this? (Printing help)

2 years ago
Page 1 / 4
Share:

Please Login or Register