Activity
 
lee.g
lee.g
Group: Registered
Joined: 2017/01/28
Estimable Member
4
I am certain you are correct with your diagnosis. The heat b...

In forum Assembly and first prints troubleshooting

3 months ago
This is a fairly simple problem to resolve if familiar with ...

In forum Assembly and first prints troubleshooting

3 months ago
Highly recommend AES3D. Email address is sales@aes3d.co.uk ...

In forum General discussion, announcements and releases

3 months ago
It's possible they have updated them now. I can't remember ...

In forum General discussion, announcements and releases

3 months ago
@ido-s I downloaded them about a month ago and the filament ...

In forum General discussion, announcements and releases

3 months ago
Yes 0.2mm and your Esun PETG should be fine. I would recom...

In forum General discussion, announcements and releases

3 months ago
I would also recommend to strip clean and re-apply thermal t...

In forum Hardware, firmware and software help

3 months ago
You need to use a separator like glue stick or the preferred...

In forum General discussion, announcements and releases

4 months ago
Do you mean its in an enclosure I.E a custom made box for th...

In forum Coronavirus (COVID-19)

4 months ago
Are you printing inside an enclosure. ASA likes an enclosur...

In forum Coronavirus (COVID-19)

4 months ago
Please stop blindly put this post up Peter. In this case it...

In forum How do I print this? (Printing help)

4 months ago
Thanks Karl that is certainly the type of material that shou...

In forum Hardware, firmware and software help

4 months ago
Thats a shame. If you were UK i could've posted you an ABS ...

In forum Hardware, firmware and software help

4 months ago
You could try it and see how it holds up. It might let you ...

In forum Hardware, firmware and software help

4 months ago
Zipped model Fan-duct-MK2S.zip Print at 0.2mm layer heigh...

In forum Hardware, firmware and software help

4 months ago
Tried to upload my design but it won't let me.

In forum Hardware, firmware and software help

4 months ago
I agree with Karl-Herbert about changing the fan shroud. Al...

In forum Hardware, firmware and software help

4 months ago
Does it happen when the part cooling fan kicks in. If yes t...

In forum Hardware, firmware and software help

4 months ago
For me there are a couple of obvious flaws with the 2.5S (i ...

In forum Hardware, firmware and software help

4 months ago
Fiberlogy is my favourite.

In forum General discussion, announcements and releases

4 months ago
Page 1 / 8
Share:

Please Login or Register