Notifications
Clear all
kursat.u
kursat.u
Group: Registered
Joined: 2017/04/18
Eminent Member
2
Try setting the volumetric speed for that filament. This is ...

In forum Hardware, firmware and software help

4 years ago
Try setting the volumetric speed for that particular filamen...

In forum General discussion, announcements and releases

4 years ago
Try setting the volumetric speed for that particular filamen...

In forum General discussion, announcements and releases

4 years ago
Try setting the volumetric speed for that particular filamen...

In forum Others (Archive)

4 years ago
If you enable . supports everywhere , then bottom interface ...

In forum General discussion, announcements and releases

4 years ago
Here is the top interface of the same part that is correctly...

In forum General discussion, announcements and releases

4 years ago
Bottom interface layer is not generated (long open defect?)

In forum General discussion, announcements and releases

4 years ago
Not tried it but this one seems iuteresting.

In forum General discussion, announcements and releases

4 years ago
@douglas.w2 , Did you get your corexy working with MMU1? I a...

In forum Others (Archive)

5 years ago
I have also been using MMMU1 and very happy with it and my ...

In forum General discussion, announcements and releases

5 years ago
Made one, works great. It takes quite a bit of time to print...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 years ago
I was thinking of the same and maybe I'll build a zaribo 330...

In forum General discussion, announcements and releases

6 years ago
Here is my notes from the Maker Fair. Summary; I saw the MMU...

In forum General discussion, announcements and releases

6 years ago
Apparently, there will be a showing of the MMU2 for the firs...

In forum General discussion, announcements and releases

6 years ago
WD40 is a penetrating oil, not recommended at all. I recall ...

In forum Hardware, firmware and software help

6 years ago
Here are come comments in this thread. MMU is working fine f...

In forum General discussion, announcements and releases

6 years ago
What a rip off! They are making their customer pay for their...

In forum General discussion, announcements and releases

6 years ago
I am still confused. Now I see the upgrades below at the pru...

In forum General discussion, announcements and releases

6 years ago
You can set the Bowden tube length even individually via fac...

In forum Hardware, firmware and software help

6 years ago
Thanks for the very useful info. I had the same problem , mo...

In forum General discussion, announcements and releases

6 years ago
Page 1 / 2
Share: