kryss.e
kryss.e
Group: Registered
Joined: 2017/01/22
Trusted Member
3
Good point, steven-p8 - should I remain 1.75mm and merely in...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
I don'n know - that's why I started this thread, to find out...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Because I don't have a spare $5000.

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Duly noted, thanks for your input 🙂

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Hi Tim, Thanks a lot 🙂 That's what I have worked out needs...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
I will need to change the entire hotend setup, as the 3mm is...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
Making the MK3 3mm instead of 1.75mm

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
@nealc, I sympathize with you, I've had more than my share o...

In forum General discussion, announcements and releases

4 months ago
I found the solution, you can find it here: Thanks everyone...

In forum Hardware, firmware and software help

5 months ago
This same thing also happens in Slic3R PE 1.42.0-beta too. ...

In forum Hardware, firmware and software help

5 months ago
I tried to upload a screenshot of this issue, but this new f...

In forum Hardware, firmware and software help

5 months ago
Slic3r PE 1.42.02 - soluble interface is not just an interfa...

In forum Hardware, firmware and software help

5 months ago
I found a solution, you can read all about it here:

In forum Hardware, firmware and software help

5 months ago
Why does the Zaribo firmware also recommend using Arduino 1....

In forum Hardware, firmware and software help

5 months ago
Hi Peter, I tried using 3.6.0 RC1 compiled in 1.6.9 as sugg...

In forum Hardware, firmware and software help

5 months ago
Hi Peter, Thanks, I just need 3.6.0 to compile and flash to...

In forum Hardware, firmware and software help

5 months ago
Using Arduino 1.6.9 with the recommended 3.6.0 firmware and ...

In forum Hardware, firmware and software help

6 months ago
Okay... Where did you get the working 3.6.0 firmware from? ...

In forum Hardware, firmware and software help

6 months ago
I've found out WHY it doesn't work! Arduino 1.6.9, what Pru...

In forum Hardware, firmware and software help

6 months ago
Your work is amazing! The attention to realistic retails and...

In forum Awesome prints (Hall Of Fame)

6 months ago
Page 1 / 3
Share:

Please Login or Register