Activity
 
Notifications
Clear all
kpreid
kpreid
Group: Registered
Joined: 2018/01/06
Trusted Member
3
You could have simply shared the information you wanted to s...

In forum How do I print this? (Printing help)

8 months ago
The first layer photo isn't quite focused and lit well enoug...

In forum How do I print this? (Printing help)

8 months ago
From a web search I found this help article which links to t...

In forum General discussion, announcements and releases

9 months ago
You can build a plate full of parts with unique number label...

In forum General discussion, announcements and releases

2 years ago
The heatbed cable should always be “floating” behind the hea...

In forum General discussion, announcements and releases

2 years ago
Yes, the bottom left corner of the print detached. Besides b...

In forum General discussion, announcements and releases

2 years ago
If you turn off “Auto-center parts” in the Preferences, then...

In forum General discussion, announcements and releases

2 years ago
Interesting! The top surface of your first-layer swatch look...

In forum General discussion, announcements and releases

2 years ago
That looks like the usual nozzle too high for the first laye...

In forum General discussion, announcements and releases

2 years ago
Mechanically, it can work by itself but the filament entry w...

In forum Assembly and first prints troubleshooting

2 years ago
In particular, if the printer hasn't homed since the last po...

In forum General discussion, announcements and releases

2 years ago
When you watch it extrude, does the plastic come out straigh...

In forum How do I print this? (Printing help)

2 years ago
Some possibilities of what the problem is, if this is incons...

In forum How do I print this? (Printing help)

2 years ago
I'm not sure, but those lines look more like problems with e...

In forum How do I print this? (Printing help)

2 years ago
That is definitely far too high. The nozzle should be close ...

In forum General discussion, announcements and releases

2 years ago
The Z setting that works for you will depend on exactly what...

In forum General discussion, announcements and releases

2 years ago
Your first layer is too close to the bed. This means that th...

In forum General discussion, announcements and releases

2 years ago
I've heard that using the wrong sort of grease can degrade t...

In forum General discussion, announcements and releases

2 years ago
It can take a surprising amount of of extrusion to adequatel...

In forum General discussion, announcements and releases

2 years ago
The layers just below the top edge of a circular hole, where...

In forum How do I print this? (Printing help)

2 years ago
Page 1 / 5
Share: