Kevin Reid
Kevin Reid
Group: Registered
Joined: 2018/01/06
Trusted Member
3
4 mm is really thick. For walls, two extrusion widths (0.8 m...

In forum General discussion, announcements and releases

1 day ago
If there's a problem with the filament sensor, I would expec...

In forum General discussion, announcements and releases

4 days ago
Could be a bad wire to the extruder. As Z moves up the angle...

In forum General discussion, announcements and releases

4 days ago
The black dot is probably a result of filament getting stuck...

In forum How do I print this? (Printing help)

1 month ago
Since flexible filament is squishier, it may not be pushing ...

In forum How do I print this? (Printing help)

2 months ago
Both too high and too low can result in messes. If the nozzl...

In forum Assembly and first prints troubleshooting

2 months ago
It looks like your Z is far too high. A first layer should n...

In forum Assembly and first prints troubleshooting

2 months ago
Yes, the SD card is only used for print files. You can use a...

In forum General discussion, announcements and releases

2 months ago
I haven't printed MMU2S parts, but all of the MK3/S printer ...

In forum General discussion, announcements and releases

3 months ago
For adhesion on the textured sheet, try setting your Live Z ...

In forum General discussion, announcements and releases

4 months ago
For PETG, get and use the powder-coated (textured) sheet. Th...

In forum General discussion, announcements and releases

4 months ago
I'm not personally familiar with the properties of PVA but t...

In forum How do I print this? (Printing help)

4 months ago
The printer doesn't have any networking. You'll need to add ...

In forum General discussion, announcements and releases

4 months ago
"Loose or worn" does seem like what's going on with that muc...

In forum General discussion, announcements and releases

4 months ago
I've had results like that and I suspect it comes down to th...

In forum General discussion, announcements and releases

4 months ago
The bottom of the fan duct (fan-shroud) should be parallel w...

In forum Assembly and first prints troubleshooting

4 months ago
Can't say I recommend using PETG with the smooth sheet, but ...

In forum General discussion, announcements and releases

4 months ago
The assembled printer and the kit have all the same features...

In forum General discussion, announcements and releases

5 months ago
Your Live Z setting is way too low, causing the already-extr...

In forum General discussion, announcements and releases

5 months ago
Have you tried swapping which filament you're loading into w...

In forum Assembly and first prints troubleshooting

5 months ago
Page 1 / 3
Share:

Please Login or Register