|
Guys, I think I have resolved the issue. I completely disas... In forum Hardware, firmware and software help |
4 years ago |
|
@pcweber Can you shed some insight as to what causes the gea... In forum Hardware, firmware and software help |
4 years ago |
|
Issue: Filament not getting through? In forum Hardware, firmware and software help |
4 years ago |
|
...printing one piece at a time.
The Simplify3D Factory fi... In forum Others (Archive) |
6 years ago |
|
in here
Reviewed that thread (and some external searching)... In forum Others (Archive) |
6 years ago |
|
Page 9, PLA filament (or PETG, APLA, htPLA, PC-max....) not... In forum Others (Archive) |
6 years ago |
|
230 for the Hot-end is way too much for PLA....
And the bed... In forum Others (Archive) |
6 years ago |
|
have a look in this thread
Simplify3D settings
regards ... In forum Others (Archive) |
6 years ago |
|
I think in Simplify3D in Under HELP/Configuration Assistant ... In forum Others (Archive) |
6 years ago |
|
Okay, I have adjusted the settings as I think you're suggest... In forum Others (Archive) |
6 years ago |
|
230 for the Hot-end is way too much for PLA....
And the bed... In forum Others (Archive) |
6 years ago |
|
What temperature are you using on the Bed?
The bed tempera... In forum Others (Archive) |
6 years ago |
|
You can try to squish the first layer a little better by adj... In forum Others (Archive) |
6 years ago |
|
What material are you printing in?
Sorry, should have clar... In forum Others (Archive) |
6 years ago |
|
Edges lifting – Cessna 152 Trainer In forum Others (Archive) |
6 years ago |
