Karl Herbert
Karl Herbert
Group: Registered
Joined: 2018/03/05
Famed Member
@richard-alpert You can create a separate start/end etc. cod...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
@charles-h13 I also like to buy nozzles from Tringlelabs, be...

In forum General discussion, announcements and releases

3 days ago
@charles-h13 Many thanks for this interesting contribution. ...

In forum General discussion, announcements and releases

3 days ago
@jer-n Thank you for the feedback and I'm pleased that the p...

In forum Hardware, firmware and software help

3 days ago
@ignacmc I think that due to the dimensions of the mosquito ...

In forum General discussion, announcements and releases

3 days ago
Why did I do this? I have a lot of MK3 spare parts and have ...

In forum General discussion, announcements and releases

3 days ago
@crawlerin I rebuilt it according to Tom's idea and stabiliz...

In forum General discussion, announcements and releases

3 days ago
14 to 15AWG would be appropriate.

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
Addition: I have used flexible silicone cable like this for ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
I would reassemble (not extend) all cables from the PSU to t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
Another possibility: PC4_M8_E3D_V6_capricorn

In forum Hardware, firmware and software help

3 days ago
@ignacmc I designed the PTFE tube to be a bit longer anyway,...

In forum General discussion, announcements and releases

3 days ago
@charles-h13 I would rather run the printerfarm in a studio ...

In forum General discussion, announcements and releases

3 days ago
@jurassic73 These relays are controlled by the GPIO pins of ...

In forum Hardware, firmware and software help

4 days ago
@ignacmc when using Pc4-M8 you have to make the PTFE tube ab...

In forum General discussion, announcements and releases

4 days ago
@nitschke-heiko Gehäuse MK3 -> EN AW-7075 (nicht gedruckt...

In forum Hilfe zur Hardware, Firmware und Software

4 days ago
@3dprintingscience Printed in a case at 45 degrees C. (275/1...

In forum General discussion, announcements and releases

4 days ago
@micachilli make changes in Configuration_prusa.h - // Maxte...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 days ago
@lukas-grandits Zum Thema "Layershift" wurde schon einiges g...

In forum Grossartige Drucke & Tipps zum Drucken

4 days ago
Anyone interested in 3D printing should be prepared to inves...

In forum General discussion, announcements and releases

4 days ago
Page 2 / 178
Share:

Please Login or Register