Karl Herbert
Karl Herbert
Group: Registered
Joined: 2018/03/05
Famed Member
@sonntag-marcus Überprüfe zuerst mal alle MMU2 Leitungen und...

In forum Hilfe zur Hardware, Firmware und Software

10 hours ago
@zahnatomletsplay well, let's hope that it was the linear be...

In forum Hardware, firmware and software help

10 hours ago
RE: Prusa Mini Drivers Win7

In forum Hardware, firmware and software help

1 day ago
Hello and welcome to the Prusaforum! If the objects are smal...

In forum PrusaSlicer

1 day ago
Hello and welcome to the Prusaforum! Did you lubricate the l...

In forum Hardware, firmware and software help

1 day ago
This is not a problem for small objects but rather for large...

In forum General discussion, announcements and releases

1 day ago
@mcmuckle You can check the internal resistance of a thermis...

In forum Hardware, firmware and software help

2 days ago
@charles-h13 I have already read a lot about "MINDA problems...

In forum General discussion, announcements and releases

2 days ago
Hallo und willkommen im Prusaforum! Wenn es ein originaler P...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

2 days ago
Hello and welcome to the Prusaforum! I use the same constell...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 days ago
@clemens-m Bezüglich der Masse musst Du Dir keine Sorgen mac...

In forum Benutzermodifikationen - OctoPrint, Gehäuse, Düsen, …

2 days ago
@sonntag-marcus Hast Du den MMU2 Sensor auch geprüft bzw. di...

In forum Hilfe zur Hardware, Firmware und Software

2 days ago
Hallo und willkommen im Prusaforum, ich würde zu Beginn erst...

In forum Hilfe zur Hardware, Firmware und Software

2 days ago
Here you will find valuable tips:

In forum Assembly and first prints troubleshooting

2 days ago
Polarity is not important when measuring the internal resist...

In forum Hardware, firmware and software help

2 days ago
@charles-h13 I think that it needs a moderator to administra...

In forum General discussion, announcements and releases

3 days ago
Hello and welcome to the Prusaforum! Did you generate an API...

In forum PrusaSlicer

3 days ago
@charles-h13 thanks for the link. I had once suggested in th...

In forum General discussion, announcements and releases

3 days ago
Then I would check the thermistor with a multimeter. At room...

In forum Hardware, firmware and software help

3 days ago
@buy-uh, this message always appears with a modified firmwar...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 days ago
Page 1 / 178
Share:

Please Login or Register