Activity
 
Notifications
Clear all
jsw
jsw
Group: Registered
Joined: 2020/02/20
Famed Member
If you mean root causes of a Blob Of Doom, it's almost alway...

In forum Hardware, firmware and software help

1 month ago
I'm glad that this thread is still active. Since the pandemi...

In forum General discussion, announcements and releases

1 month ago
I was not aware that they are/were making their own. That is...

In forum General discussion, announcements and releases

1 month ago
IIAC, the Einsy is actually produced by Ultimachine, not by ...

In forum General discussion, announcements and releases

1 month ago
And many of those look worse than they actually are. Many of...

In forum Hardware, firmware and software help

1 month ago
And if you want some entertainment, surf the 3d Print Blob O...

In forum Hardware, firmware and software help

1 month ago
If you have curl-up, don't be afraid to use an adhesion boos...

In forum How do I print this? (Printing help)

1 month ago
What are your requirements? How large of a build volume do ...

In forum General discussion, announcements and releases

1 month ago
Many filament manufacturers and 3d printer makers often reco...

In forum General discussion, announcements and releases

1 month ago
For most 3d print plastics, if you want a more forgiving bon...

In forum General discussion, announcements and releases

1 month ago
During Covid I printed a number of smaller various marble ma...

In forum Awesome prints (Hall Of Fame)

1 month ago
What size gear(s) are you printing? I have done quite a few ...

In forum How do I print this? (Printing help)

1 month ago
I made a makeshift dehydrator out of one of my dryboxes shor...

In forum How do I print this? (Printing help)

1 month ago
First of all, your homeowner's insurance may cover things li...

In forum Hardware, firmware and software help

1 month ago
I have used both PS and Cura with the Prusa MK3S for a numbe...

In forum PrusaSlicer

1 month ago
Yes, you can kind of buff the surface of the Layerneer with ...

In forum General discussion, announcements and releases

2 months ago
I almost always use IPA to clean the build plates, PEI, text...

In forum General discussion, announcements and releases

2 months ago
If you have a new build plate with that new XL, this makes s...

In forum General discussion, announcements and releases

2 months ago
I usually let them run on dehydrate overnight, ~120F (~48c) ...

In forum General discussion, announcements and releases

2 months ago
Where's Chuck?

In forum Awesome prints (Hall Of Fame)

3 months ago
Page 1 / 153
Share: