Activity
 
jsw
jsw
Group: Registered
Joined: 2020/02/20
Reputable Member
5
Hatchbox is my go-to filament here in the States. Sometimes...

In forum General discussion, announcements and releases

23 hours ago
Yet again, I will make a call-out for the Layerneer Bed Weld...

In forum Assembly and first prints troubleshooting

1 day ago
I don't use the Mini, but I am sold on the Layerneer Bed Wel...

In forum Assembly and first prints troubleshooting

1 day ago
Thanks. I'll know to steer away from MakerGeeks, which I hav...

In forum General discussion, announcements and releases

1 day ago
The one firmware upgrade I did worked well, and first time, ...

In forum General discussion, announcements and releases

2 days ago
You may then have to at least partially assemble the heat be...

In forum Assembly and first prints troubleshooting

2 days ago
In looking closely at your photo, it appears that there's so...

In forum Hardware, firmware and software help

2 days ago
Using the Part workbench in Freecad, it's possible to 'drill...

In forum PrusaSlicer

2 days ago
A quick sanity check would be to see if all of the holes in ...

In forum Assembly and first prints troubleshooting

2 days ago
Do you brush off the nozzle prior to the print? I've gotten...

In forum How do I print this? (Printing help)

2 days ago
With all of the reports here and on other fora of 'things go...

In forum General discussion, announcements and releases

2 days ago
I would use a low temp electric oven, preheated and stabiliz...

In forum General discussion, announcements and releases

2 days ago
Heat or cooling, maybe? That can un-stick quite a few stuck...

In forum Hardware, firmware and software help

2 days ago
When we built the house (5y ago) the code required smoke det...

In forum General discussion, announcements and releases

3 days ago
Sounds to me like it could be dirty (hopefully) or worn (not...

In forum Hardware, firmware and software help

4 days ago
Already have them. One in the garage, the other in the kitc...

In forum General discussion, announcements and releases

4 days ago
Mine was not inserted. It was in one of the parts kits. It...

In forum General discussion, announcements and releases

5 days ago
Update (it will not let me simply edit my last post). The re...

In forum General discussion, announcements and releases

5 days ago
Well, as I said, I ordered the digital thermometer. As an as...

In forum General discussion, announcements and releases

5 days ago
Assuming PrusaSlicer, you can orient in any position using t...

In forum PrusaSlicer

5 days ago
Page 1 / 20
Share:

Please Login or Register