josefprusa
josefprusa
Group: Admin
Joined: 2015/04/26
Title: Member Admin
2
We literally cost 10€ less per spool with our premium inhous...

In forum General discussion, announcements and releases

6 months ago
test

In forum Slic3r

2 years ago
Tohle se stane, kdyz se to dotahuje do krve, tim se pak troc...

In forum Ostatní (Archiv)

2 years ago
Hello there 🙂 It is a big surprise to see problems on supp...

In forum Others (Archive)

2 years ago
I do not know, where the original poster got the data. But w...

In forum Others (Archive)

2 years ago
PSU section from the upcoming article reviewing last two mon...

In forum Hardware, firmware and software help

2 years ago
Vše funguje jak má. Jediné, co mě po třech dnech strávených...

In forum Ostatní (Archiv)

2 years ago
MK3 has independent CE testing from AKPtesting. It is attach...

In forum Hardware, firmware and software help

2 years ago
Jak kit tak sestavená má přibalený pouze jeden plát.

In forum Ostatní (Archiv)

2 years ago
I just got more info about the layershifts. As I calibrated ...

In forum General discussion, announcements and releases

2 years ago
Re: MK3 zastavenie pri tlaci. FW:prusa3d_fw_3_1_1_rc4_b143

In forum Ostatní (Archiv)

2 years ago
Chtel jsem to postnout ale predbehl jste me 🙂 2.1.3 je ven...

In forum Ostatní (Archiv)

2 years ago
But when I look at the Filament Settings tab, the "Extrusion...

In forum Others (Archive)

2 years ago
Thank you for your testing. New Drivers 2.1.3 are out 😉

In forum Others (Archive)

2 years ago
OctoPrint issues and tips

In forum General discussion, announcements and releases

2 years ago
Change the infill pattern to grid, it is bleeding thru thr p...

In forum Others (Archive)

2 years ago
Should be fixed in the new drivers

In forum Others (Archive)

2 years ago
UPDATE! Drivery 2.1.2 s vyresenym preplnovanim na test

In forum Ostatní (Archiv)

2 years ago
Thanks Joe. Any chance the extrusion issue may also apply to...

In forum Others (Archive)

2 years ago
EDIT 3.1. 21:52 CET - In the original link, some settings we...

In forum Others (Archive)

2 years ago
Page 1 / 38
Share:

Please Login or Register