|
Cura doesn't generate a wipe tower for more than two colors.... In forum Others (Archive) |
6 years ago |
|
The answer : 🙁 In forum Software (Archive) |
6 years ago |
|
The current version of Slic3r PE is not able to generate a S... In forum Others (Archive) |
6 years ago |
|
Slic3r PE suitable for other MM printers? In forum Software (Archive) |
6 years ago |
|
I've heard a lot of people use just Windex, but for every po... In forum Print tips (Archive) |
6 years ago |
|
Would be cool if it could detect that sort of stuff, but I d... In forum Others (Archive) |
7 years ago |
|
OctoPrint has a Firmware Updater plug-in ... In forum Others (Archive) |
7 years ago |
|
Merv,
You are referring to 'the original posters post' and ... In forum Improvements (Archive) |
7 years ago |
|
This forum seems to be populated with the most unbelievably ... In forum Improvements (Archive) |
7 years ago |
|
Peter,
I don't know what you base your comment that I'm not... In forum Improvements (Archive) |
7 years ago |
|
Peter,
Think about it ...
It takes a leisurely 10 minutes... In forum Improvements (Archive) |
7 years ago |
|
Not sure I follow your logic here.
The risk of higher volta... In forum Improvements (Archive) |
7 years ago |
|
9 min in an 18°C room. In forum Others (Archive) |
7 years ago |
|
These are stepper motors (), more precisely Nema 17 (), whic... In forum Others (Archive) |
7 years ago |
|
Several people reported good results with RJ4JP-01-08. These... In forum Hardware, firmware and software help |
7 years ago |
|
@Omikron : Just try it. With a layer height of 0.05 and a la... In forum General discussion, announcements and releases |
7 years ago |
|
The original power supply on my Mk2 IS fanless, but I also e... In forum Others (Archive) |
7 years ago |
|
I have a 'generic' Prusa i3, also equiped with an E3D hotend... In forum Others (Archive) |
7 years ago |
|
@Omikron : You said ' in S3D it's limited to 1.2x the layer ... In forum General discussion, announcements and releases |
7 years ago |
|
That depends on selected printing speed, layer height, layer... In forum Prusa i3 kit (Archive) |
8 years ago |
