jordan.c
jordan.c
Group: Registered
Joined: 2016/10/09
Estimable Member
4
checklist after long break from printing

In forum Prusa i3 kit (Archive)

2 years ago
Well I printed something else and it came out fine. In fact...

In forum Prusa i3 kit (Archive)

3 years ago
curious, here in germany you can get 100% acetone in every d...

In forum Prusa i3 kit (Archive)

3 years ago
I am surprised you pasted calibration, one half of the bed i...

In forum Prusa i3 kit (Archive)

3 years ago
What happens when you exceed the build area?

In forum Prusa i3 kit (Archive)

3 years ago
Home Depot... How about this? Just easier to order via ...

In forum Prusa i3 kit (Archive)

3 years ago
No way! I was freaking out pretty bad this morning, thanks ...

In forum Prusa i3 kit (Archive)

3 years ago
Another bed bites the dust!

In forum Prusa i3 kit (Archive)

3 years ago
Home Depot... perfect, thank you

In forum Prusa i3 kit (Archive)

3 years ago
100% acetone

In forum Prusa i3 kit (Archive)

3 years ago
MK2 Maintenance

In forum Prusa i3 kit (Archive)

3 years ago
"Oh must be moisture cause i can't think of anything else." ...

In forum Prusa i3 kit (Archive)

3 years ago
Could too hot room temp prevent sticking to bed?

In forum Prusa i3 kit (Archive)

3 years ago
If final release 3.0.10 Firmware, why is it not on front pag...

In forum Others (Archive)

3 years ago
Firmware 3.0.10 just released!

In forum Others (Archive)

3 years ago
solved It was a bug when you cancelled a print before homin...

In forum Prusa i3 kit (Archive)

3 years ago
Openscad - parts that should fit into each other

In forum Software (Archive)

3 years ago
Well, In my enclosure that is not finished yet, but temperat...

In forum Improvements (Archive)

4 years ago
Is there a chart somewhere with the recommended ambient temp...

In forum Improvements (Archive)

4 years ago
Why is that too hot for you? Sorry if that's a newbie quest...

In forum Improvements (Archive)

4 years ago
Page 1 / 6
Share:

Please Login or Register