JohnOCFII
JohnOCFII
Group: Registered
Joined: 2016/08/18
Estimable Member
4
So you bought original E3D V6 that is all metal? I don't see...

In forum Print tips (Archive)

4 years ago
[quote="valent.t" So you bought original E3D V6 that is all ...

In forum Print tips (Archive)

4 years ago
Those look nice, John. I tried your MG Raptor PLA settings ...

In forum Others (Archive)

4 years ago
Therefore, the original Xinyujie xyj12b3010h offers the wide...

In forum Improvements (Archive)

4 years ago
Therefore, the original Xinyujie xyj12b3010h offers the wide...

In forum Improvements (Archive)

4 years ago
I looked at the settings comparing them to the one from Prus...

In forum Others (Archive)

4 years ago
JohnOFII: I downloaded your .fff file from github to try ou...

In forum Others (Archive)

4 years ago
Print came out fine, as you can see in my previous post. It...

In forum Others (Archive)

4 years ago
Is the "john...." something one yours? Yes - John O'Shaug...

In forum Others (Archive)

4 years ago
Conceptually, thing of OctoPrint as a conduit through which ...

In forum Software (Archive)

4 years ago
I think I may have solved the problem! Thanks for the updat...

In forum Others (Archive)

4 years ago
I don't think so, but that doesn't mean that they all don't ...

In forum Others (Archive)

4 years ago
VortyZA: I am not actually sure what the percentage is on m...

In forum Others (Archive)

4 years ago
A 20mm cube will not give correct figures due to acceleratio...

In forum Prusa i3 kit (Archive)

4 years ago
When I go into the overall print statistics, it says that th...

In forum Prusa i3 kit (Archive)

4 years ago
Hello Guys, I started experimenting with the maximum print ...

In forum Prusa i3 kit (Archive)

4 years ago
Well.. with the painters tape on the bed, and heat off, the ...

In forum Others (Archive)

4 years ago
Or is there a alternative to ABS, for temperature resistance...

In forum Others (Archive)

4 years ago
Have you used the right screws? I can see the end of my scre...

In forum Others (Archive)

4 years ago
For what it's worth, I ended up reflashing the firmware usin...

In forum Others (Archive)

4 years ago
Page 2 / 12
Share:

Please Login or Register