Johncoffee
Johncoffee
Group: Registered
Joined: 2017/07/23
Eminent Member
2
Thanks for your note back bubnikv - fully understood !

In forum How do I print this? (Printing help)

2 years ago
Thanks bubnikv for your reply. Please allow me to ask: why ...

In forum How do I print this? (Printing help)

2 years ago
Printing with support question

In forum How do I print this? (Printing help)

2 years ago
I have had the same issue. The problem was, that the xy orig...

In forum Hardware, firmware and software help

2 years ago
To me it looks like the first layer is too high above the pr...

In forum General discussion, announcements and releases

2 years ago
I got I just found it after changing "parameter XY separatio...

In forum How do I print this? (Printing help)

2 years ago
Question regarding support structure in Slic3r 1.41

In forum How do I print this? (Printing help)

2 years ago
Dear Peter, Gotcha. Thanks for your response. All parts I've...

In forum Hardware, firmware and software help

2 years ago
I don't get 4.2mm - not at all. I measure ~7.5mm. I have rel...

In forum Hardware, firmware and software help

2 years ago
Thanks Peter - will try this !

In forum Hardware, firmware and software help

2 years ago
Length of PTFE 41mm in MMU hotend assembly too long?

In forum Hardware, firmware and software help

2 years ago
This is what the support just told me when asking about how ...

In forum General discussion, announcements and releases

2 years ago
I used octoprint to make the adjustments. It places an M907 ...

In forum General discussion, announcements and releases

2 years ago
I also print from SD since I've upgraded to MMU - because Oc...

In forum Hardware, firmware and software help

2 years ago
New MMU filament spool stand

In forum Others (Archive)

2 years ago
Maybe a stupid question- but what is PETG with HIPS interfac...

In forum Others (Archive)

2 years ago
Fair point! I like your idea.

In forum Others (Archive)

2 years ago
I've inverted the spools to unwind the filament via the top....

In forum Others (Archive)

3 years ago
I'm using the slab since I've bought the printer. First with...

In forum Others (Archive)

3 years ago
I'm printing with good success using this setup: ...

In forum Others (Archive)

3 years ago
Page 1 / 3
Share:

Please Login or Register