Activity
 
joan.t
joan.t
Group: Moderator
Joined: 2015/10/30
Title: Veteran Member Moderator
is your error comparable to model size? if you double the mo...

In forum How do I print this? (Printing help)

58 mins ago
Hi James, ~did you Lubricate your Linear bearings? poorly lu...

In forum How do I print this? (Printing help)

1 hour ago
If the thermistor is short circuit, you will get a Maxtemp e...

In forum Discussion générale, annonces et nouveautés

2 hours ago
I believe Printed Solid should be able to help. regards Joa...

In forum Hardware, firmware and software help

2 hours ago
If you do sand blast, Use fresh abrasive media or fresh bead...

In forum General discussion, announcements and releases

2 hours ago
@mteilgard If you get a part stuck again, Try dribbling some...

In forum General discussion, announcements and releases

2 hours ago
Hi Manum, could this be caused by Elephants Foot Correction?...

In forum PrusaSlicer

1 day ago
have you tried dishsoap and Hot water? washed thoroughly wit...

In forum How do I print this? (Printing help)

1 day ago
Hi Peter, The Textured bed can be very difficult to use. as ...

In forum Assembly and first prints troubleshooting

1 day ago
Hi Antonius, the developers use Github, for change requests,...

In forum PrusaSlicer

1 day ago
if you can't find the grub screw, check your magnets under t...

In forum Hardware, firmware a software (Pomoc)

1 day ago
Ujistěte se, že vaše sestava je neuvěřitelně čistá,Používám ...

In forum Obecná diskuze, oznámení a novinky

2 days ago
Good afternoon nilbogaus, are you using the latest firmware ...

In forum How do I print this? (Printing help)

2 days ago
Good Morning LR, the textured sheet is thinner, overall than...

In forum Assembly and first prints troubleshooting

3 days ago
Good morning Don, do you have pictures of this issue? Regard...

In forum General discussion, announcements and releases

4 days ago
@charles-h13 and a spare heater, and spare wire to make repa...

In forum Hardware, firmware and software help

4 days ago
when your printer is turned on, and at rest, I suspect your ...

In forum Hardware, firmware and software help

4 days ago
what thickness is the wall you are trying to slice? you can...

In forum PrusaSlicer

6 days ago
Hi Arklan, Did you sort this by filing the Ubolt? or is this...

In forum Assembly and first prints troubleshooting

6 days ago
What filament are you using?, what temperatures are you usin...

In forum Assembly and first prints troubleshooting

7 days ago
Page 1 / 273
Share:

Please Login or Register