|
Good result 😃 In forum General discussion, announcements and releases |
9 hours ago |
|
when you mix the epoxy there is a chance of some raw epoxy r... In forum How do I print this? (Printing help) |
11 hours ago |
|
Mind you, with three perimeters per layer as suggested by Th... In forum How do I print this? (Printing help) |
14 hours ago |
|
this is effectively a prompt, to confirm that you have the c... In forum Hardware, firmware and software help |
16 hours ago |
|
Hi Greeny Meanie, May I suggest that you do not use 100% Inf... In forum How do I print this? (Printing help) |
18 hours ago |
|
In My opinion, the first layer calibration tool wrapped in t... In forum General discussion, announcements and releases |
18 hours ago |
|
i had MMU3 with Mk3s, and I used a filament sensor with a 5 ... In forum Assembly and first prints troubleshooting |
1 day ago |
|
Hi, I have been printing for quite a while without needing ... In forum Hardware, firmware and software help |
2 days ago |
|
just a thought.. do you have a Smart phone? if you do, can y... In forum General discussion, announcements and releases |
2 days ago |
|
First layer pictures from your printer, may help. I wrote t... In forum General discussion, announcements and releases |
2 days ago |
|
If Z is at 0.000 then you have approximately -2.000 more adj... In forum Assembly and first prints troubleshooting |
2 days ago |
|
I had a similar issur and it was down to the pinda wire. I r... In forum Hardware, firmware and software help |
2 days ago |
|
Thanks Oliver, you are the first person in 4 years to notice... In forum Assembly and first prints troubleshooting |
3 days ago |
|
Hi Overlander... Personally, I think the built in first laye... In forum Assembly and first prints troubleshooting |
3 days ago |
|
if you are only missing three balls, leave one out of one si... In forum Assembly and first prints troubleshooting |
3 days ago |
|
Hi Luke, when I Downloaded your 250Hz model, Prusa slicer a... In forum Hardware, firmware and software help |
3 days ago |
|
The MMU Filament sensor is different to the standard setup ... In forum General discussion, announcements and releases |
3 days ago |
|
Hi Chris, do you have access to an ethernet cable connection... In forum General discussion, announcements and releases |
4 days ago |
|
Since I have had the MMU3, I have not had to push any of the... In forum Hardware, firmware and software help |
4 days ago |
|
Hi Havard, This site is primarily a Peer to Peer user suppor... In forum General discussion, announcements and releases |
4 days ago |