Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Title: Veteran Member Moderator
I don't think the MMU3 aware Firmware for Mk3.9 and mk4 prin...

In forum Hardware, firmware and software help

1 week ago
Wipe Build plate with Windex, and allow to dry, before print...

In forum General discussion, announcements and releases

1 week ago
I Believe the graphics are printed on after the 3D print has...

In forum How do I print this? (Printing help)

1 week ago
In the time I have been moderating, no one, so far, has been...

In forum Hardware, firmware and software help

1 week ago
This would be better raised on the Prusa Connect Git Hub Pag...

In forum General discussion & User Experience & Ideas

1 week ago
the pictures are still in your first post, however they are ...

In forum Hardware, firmware and software help

1 week ago
I would delay printing mmu3 parts as the beta testers have j...

In forum Hardware, firmware and software help

1 week ago
First layer height squish is adjusted with Z Height i think ...

In forum PrusaSlicer

1 week ago
try the other one. regards Joan

In forum Hardware, firmware and software help

1 week ago
Superlube will do Regards Joan

In forum General discussion, announcements and releases

1 week ago
Is this the firmware that you loaded? regards Joan

In forum Hardware, firmware and software help

1 week ago
if the gear teeth have not been lubricated, this could be ru...

In forum General discussion, announcements and releases

1 week ago
Yes, Sequential Printing regards Joan

In forum General discussion, announcements and releases

1 week ago
try this Link I bought And after programming with Arduino I...

In forum General discussion & User Experience & Ideas

1 week ago
edit it here... expert mode in Prusa Slicer

In forum Hardware, firmware and software help

1 week ago
Load cell for automatic bed levelling Need a new mk4 heat s...

In forum Hardware, firmware and software help

1 week ago
i haven't pushed any mmu buttons since the MMU3 upgrade.MMU2...

In forum Hardware, firmware and software help

2 weeks ago
Try Zipping the Scad file, then the ZIP should be attachable...

In forum Community mods

2 weeks ago
I would try all of the code, at first... reards, Joan

In forum PrusaSlicer

2 weeks ago
IPA sprayed on and left to soak for a short while, should lo...

In forum General discussion, announcements and releases

2 weeks ago
Page 2 / 483
Share: