Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Title: Veteran Member Moderator
My brain is not on the right page. Sorry! I was thinking p...

In forum Hardware, firmware and software help

11 hours ago
You can learn something new, every day!Lolregards Joan

In forum General discussion, announcements and releases

1 day ago
Can you please show a picture of the Upper part of the Nextr...

In forum Hardware, firmware and software help

1 day ago
You could delete this line from the "Printer Settings> Cu...

In forum General discussion, announcements and releases

1 day ago
I wash my bed with dish soap and water, PLA? Try 70C on bedJ...

In forum General discussion, announcements and releases

2 days ago
If this happens again, have a look at the sensor status on t...

In forum Hardware, firmware and software help

2 days ago
you are currently using Arachne for slicing perimeter genera...

In forum PrusaSlicer

3 days ago
Try adding a modifier for the area you wish to be stronger, ...

In forum General discussion, announcements and releases

3 days ago
Are you trying to support 'Bridges' ?do you have 'Don't sup...

In forum General discussion, announcements and releases

3 days ago
has your bondtech gear grub screw come loose?it should be ti...

In forum Hilfe zur Hardware, Firmware und Software

3 days ago
Did you lube the gears? could this be retraction as the gear...

In forum Hardware, firmware and software help

5 days ago
You could comment out, this line in the Printer settings>...

In forum General discussion, announcements and releases

6 days ago
Try washing the build plate with hot water and dish soap. Ri...

In forum General discussion, announcements and releases

7 days ago
I hilighted the intro line info Bed levelling is above tha...

In forum Hardware, firmware and software help

7 days ago
what's happening in the homing error? regards Joan

In forum Assembly and first prints troubleshooting

7 days ago
This works with the MMU3 as well... Unapproved by Prusa... o...

In forum General discussion, announcements and releases

7 days ago
I don't think the MMU3 aware Firmware for Mk3.9 and mk4 prin...

In forum Hardware, firmware and software help

1 week ago
Wipe Build plate with Windex, and allow to dry, before print...

In forum General discussion, announcements and releases

1 week ago
I Believe the graphics are printed on after the 3D print has...

In forum How do I print this? (Printing help)

1 week ago
In the time I have been moderating, no one, so far, has been...

In forum Hardware, firmware and software help

1 week ago
Page 1 / 482
Share: