Activity
 
joan.t
joan.t
Group: Moderator
Joined: 2015/10/30
Title: Veteran Member Moderator
is your error comparable to model size? if you double the mo...

In forum How do I print this? (Printing help)

37 mins ago
Hi James, ~did you Lubricate your Linear bearings? poorly lu...

In forum How do I print this? (Printing help)

53 mins ago
If the thermistor is short circuit, you will get a Maxtemp e...

In forum Discussion générale, annonces et nouveautés

2 hours ago
I believe Printed Solid should be able to help. regards Joa...

In forum Hardware, firmware and software help

2 hours ago
If you do sand blast, Use fresh abrasive media or fresh bead...

In forum General discussion, announcements and releases

2 hours ago
@mteilgard If you get a part stuck again, Try dribbling some...

In forum General discussion, announcements and releases

2 hours ago
Hi Manum, could this be caused by Elephants Foot Correction?...

In forum PrusaSlicer

24 hours ago
have you tried dishsoap and Hot water? washed thoroughly wit...

In forum How do I print this? (Printing help)

1 day ago
Hi Peter, The Textured bed can be very difficult to use. as ...

In forum Assembly and first prints troubleshooting

1 day ago
Hi Antonius, the developers use Github, for change requests,...

In forum PrusaSlicer

1 day ago
if you can't find the grub screw, check your magnets under t...

In forum Hardware, firmware a software (Pomoc)

1 day ago
Ujistěte se, že vaše sestava je neuvěřitelně čistá,Používám ...

In forum Obecná diskuze, oznámení a novinky

2 days ago
Good afternoon nilbogaus, are you using the latest firmware ...

In forum How do I print this? (Printing help)

2 days ago
Good Morning LR, the textured sheet is thinner, overall than...

In forum Assembly and first prints troubleshooting

3 days ago
Good morning Don, do you have pictures of this issue? Regard...

In forum General discussion, announcements and releases

4 days ago
@charles-h13 and a spare heater, and spare wire to make repa...

In forum Hardware, firmware and software help

4 days ago
when your printer is turned on, and at rest, I suspect your ...

In forum Hardware, firmware and software help

4 days ago
what thickness is the wall you are trying to slice? you can...

In forum PrusaSlicer

6 days ago
Hi Arklan, Did you sort this by filing the Ubolt? or is this...

In forum Assembly and first prints troubleshooting

6 days ago
What filament are you using?, what temperatures are you usin...

In forum Assembly and first prints troubleshooting

7 days ago
Page 1 / 273
Share:

Please Login or Register