Notifications
Clear all
JoanTabb
JoanTabb
Group: Moderator
Joined: 2015/10/30
Title: Veteran Member Moderator
There have been new printed parts for the MMU3, for the mk4 ...

In forum General discussion, announcements and releases

12 hours ago
The idler MUST NOT be tightened all of the waySee Step 38 at...

In forum Assembly and first prints troubleshooting

13 hours ago
Welcome to the MMU3 /mk4 club Joan

In forum General discussion, announcements and releases

14 hours ago
I would obtain a longer length of 6mm wide 2GT Belt, and cu...

In forum Hardware, firmware and software help

21 hours ago
Is this any help?E AXIS mk3s+Joan

In forum General software discussion

1 day ago
This happens because the elements of the model are too thin,...

In forum PrusaSlicer

1 day ago
As far as I am aware the only parts of the MMU2 which are re...

In forum Assembly and first prints troubleshooting

1 day ago
My brain is not on the right page. Sorry! I was thinking p...

In forum Hardware, firmware and software help

2 days ago
You can learn something new, every day!Lolregards Joan

In forum General discussion, announcements and releases

3 days ago
Can you please show a picture of the Upper part of the Nextr...

In forum Hardware, firmware and software help

3 days ago
You could delete this line from the "Printer Settings> Cu...

In forum General discussion, announcements and releases

3 days ago
I wash my bed with dish soap and water, PLA? Try 70C on bedJ...

In forum General discussion, announcements and releases

3 days ago
If this happens again, have a look at the sensor status on t...

In forum Hardware, firmware and software help

3 days ago
you are currently using Arachne for slicing perimeter genera...

In forum PrusaSlicer

4 days ago
Try adding a modifier for the area you wish to be stronger, ...

In forum General discussion, announcements and releases

4 days ago
Are you trying to support 'Bridges' ?do you have 'Don't sup...

In forum General discussion, announcements and releases

4 days ago
has your bondtech gear grub screw come loose?it should be ti...

In forum Hilfe zur Hardware, Firmware und Software

4 days ago
Did you lube the gears? could this be retraction as the gear...

In forum Hardware, firmware and software help

6 days ago
You could comment out, this line in the Printer settings>...

In forum General discussion, announcements and releases

1 week ago
Try washing the build plate with hot water and dish soap. Ri...

In forum General discussion, announcements and releases

1 week ago
Page 1 / 483
Share: