|
Yes one extruder for two types of filament maybe too hard a ... In forum PrusaSlicer |
2 years ago |
|
Fwiw the wipe tower is critical to me when swapping between ... In forum PrusaSlicer |
2 years ago |
|
I’ll play with this later! Any doc or spec on PrusaLink to r... In forum PrusaSlicer |
3 years ago |
|
Oh hey thanks! I found small spools, wow so cheap... I've go... In forum Hardware, firmware and software help |
3 years ago |
|
That sounds good, how can I do that? I've never ordered fila... In forum Hardware, firmware and software help |
3 years ago |
|
The simplest solution might be to get 1.75mm NYLON filament ... In forum Hardware, firmware and software help |
3 years ago |
|
@baklin Thanks, I got the MK3 to MK3S upgrade kit, and while... In forum Hardware, firmware and software help |
3 years ago |
|
Extruder cable bundle: I need new NYLON filament In forum Hardware, firmware and software help |
3 years ago |
|
FWIW it's the "TOOLCHANGE LOAD" gcode I'm editing, the bold ... In forum PrusaSlicer |
3 years ago |
|
I've had success with this method, but I wonder if folks hav... In forum PrusaSlicer |
3 years ago |
|
I just ran into this on a MK3 running the latest firmware (3... In forum Hardware, firmware and software help |
3 years ago |
|
@gutenberg- Thanks, I do have Detect Bridging Perimeters on,... In forum PrusaSlicer |
4 years ago |
|
Also of note about this design: my spouse is a physician and... In forum PrusaSlicer |
4 years ago |
|
@jbaader That's why I remodeled it (at least the North Ameri... In forum PrusaSlicer |
4 years ago |
|
OK I'm getting awesome results right now in PETG with .25mm ... In forum PrusaSlicer |
4 years ago |
|
@georgecoffindesign I'm making my stacks in Meshmixer with a... In forum PrusaSlicer |
4 years ago |
|
I've abandoned the auto-repeat approach. I got ejecting to w... In forum How do I print this? (Printing help) |
4 years ago |
|
@sembazuru It seems like now is the time for continuous prin... In forum How do I print this? (Printing help) |
4 years ago |
|
@malcolm I have my push-off code in Printer Settings > Cu... In forum PrusaSlicer |
4 years ago |
|
@znelson710 Yes adhesion is a problem for me too. For PLA, t... In forum PrusaSlicer |
4 years ago |
