Bubblehead
Bubblehead
Group: Registered
Joined: 2018/09/28
Trusted Member
3
@corey-m7 There is always dish detergent and water 😀 I prin...

In forum General discussion, announcements and releases

2 days ago
@corey-m7 I think methyl alcohol is the problem and should i...

In forum General discussion, announcements and releases

3 days ago
@cory re: "It is pretty much the same as IPA" Depending on w...

In forum General discussion, announcements and releases

3 days ago
You can try the magifying glass in the upper right corner to...

In forum General discussion, announcements and releases

6 days ago
@sil Make sure there is no debris on the back side of the bu...

In forum Hardware, firmware and software help

1 week ago
You can check if the Einsy board is seeing the PINDA by usin...

In forum Assembly and first prints troubleshooting

2 months ago
I am very curious if 3D Builder will fix an stl that Netfabb...

In forum How do I print this? (Printing help)

2 months ago
I've only had one model that the slicer could not repair and...

In forum How do I print this? (Printing help)

2 months ago
I'm assuming when you say PrusaSlicer fixed them you are ref...

In forum How do I print this? (Printing help)

2 months ago
I bought a piece of rip-stop nylon that was roughly a square...

In forum General discussion, announcements and releases

3 months ago
Are you using PrusaSlicer to open the file? Look under Conf...

In forum Hardware, firmware and software help

3 months ago
@kamil-c I was not suggesting you lay it down just rotate th...

In forum General discussion, announcements and releases

3 months ago
@sembazuru I am embarrassed to admit it but I do the nozzle ...

In forum General discussion, announcements and releases

3 months ago
I wonder if the the tearing away could be reduced/eliminated...

In forum General discussion, announcements and releases

3 months ago
Here is what I use: The hex bits that come with the torque ...

In forum General discussion, announcements and releases

3 months ago
@lawrence-b2 Re temperature test: you physically measured th...

In forum Hardware, firmware and software help

3 months ago
Two thoughts... 1. Have you put a straight edge on the bed t...

In forum Hardware, firmware and software help

3 months ago
@benltien The screw on the right looks like the least of you...

In forum Hardware, firmware and software help

3 months ago
I dinged my bed printing a part following an acetone cleanin...

In forum How do I print this? (Printing help)

3 months ago
I used Hatchbox and eSun PETG and occasionally have problems...

In forum How do I print this? (Printing help)

3 months ago
Page 1 / 4
Share:

Please Login or Register