Notifications
Clear all
JeffJordan
JeffJordan
Group: Moderator
Joined: 2016/10/20
Title: Member Moderator
3
... So I backed up and tried -.910 and -.905; both seemed pr...

In forum Assembly and first prints troubleshooting

6 years ago
💡 did you thoroughly clean the pei sheet with 99% isopr...

In forum How do I print this? (Printing help)

6 years ago
I recommend to "fine tune" it down to +/- 20µm. check out -9...

In forum Assembly and first prints troubleshooting

6 years ago
... print it in orange and paint the inside of the filament ...

In forum Hardware, firmware and software help

6 years ago
Page 2 / 72
Share: