|
I got on the tech support chat and they had me disconnect an... In forum Hardware, firmware and software help |
7 months ago |
|
Screen goes blank after boot up. In forum Hardware, firmware and software help |
7 months ago |
|
Adding MMU3 to new MK4 kit, any changes to printer needed? In forum Assembly and first prints troubleshooting |
9 months ago |
|
"Tough" resins good enough for little boxes, toy clock gears... In forum General discussion, announcements and releases |
3 years ago |
|
It's fun to post something and have someone find it useful a... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Excellent points. Makes perfect sense. I forgot about the ti... In forum Hardware, firmware and software help |
5 years ago |
|
I did read the manual when I built the printer and started u... In forum Hardware, firmware and software help |
5 years ago |
|
I closed the issue on github. Trying to clean up after mysel... In forum Hardware, firmware and software help |
5 years ago |
|
OH, now I see. If I spin the knob about 3/4 of a turn it doe... In forum Hardware, firmware and software help |
5 years ago |
|
When I spin the knob the speed doesn't change for quite a wh... In forum Hardware, firmware and software help |
5 years ago |
|
Seems to be an LCD display bug that changes the Speed settin... In forum Hardware, firmware and software help |
5 years ago |
|
I just played around with it and I see you're right - the so... In forum PrusaSlicer |
5 years ago |
|
@tim-m30 That's certainly possible. I've been scrolling arou... In forum Hardware, firmware and software help |
5 years ago |
|
One fix for the filament sensor stuck "on" In forum Assembly and first prints troubleshooting |
5 years ago |
|
I've always left the speed on 100% on the LCD, so that shoul... In forum Hardware, firmware and software help |
5 years ago |
|
That sounds like a very good theory. By the time I checked i... In forum Hardware, firmware and software help |
5 years ago |
|
Question mark on LCD display after time remaining estimate In forum Hardware, firmware and software help |
5 years ago |
