Activity
 
jbinfl
jbinfl
Group: Registered
Joined: 2018/06/21
Reputable Member
5
Good advice already in this thread... A couple of things. I...

In forum Hardware, firmware and software help

3 months ago
@vazovsky as an alternative to sterno, a wash in the sink wi...

In forum Hardware, firmware and software help

3 months ago
RE: Thekkiinngg Powder Coated PEI sheet V4 - Impressions aft...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
On Amazon you can get a roll of ESUN cleaning filament for l...

In forum General discussion, announcements and releases

4 months ago
Neat! I was looking at that one but was concerned about sizi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Yes, what vintagepc said. If you ordered and purchased it n...

In forum Assembly and first prints troubleshooting

6 months ago
Not gonna lie, that white looks good. nice job.

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
Bobstro: Excellent info on the retained values and Prusa Sli...

In forum General discussion, announcements and releases

6 months ago
perhaps this link will help. I had similar questions a whil...

In forum General discussion, announcements and releases

6 months ago
That right there is a spot on assessment. After bed cleanli...

In forum Assembly and first prints troubleshooting

6 months ago
It can happen without the Gcode modification because it take...

In forum Assembly and first prints troubleshooting

6 months ago
Felix: Your right, I was honestly not trying to be an ass, ...

In forum Assembly and first prints troubleshooting

6 months ago
I have used the filament guide that Crawlerin posted since r...

In forum General discussion, announcements and releases

6 months ago
Dave: Apologies, I mistyped. the .3mf files are what i used ...

In forum Hardware, firmware and software help

6 months ago
Felix: You might have better luck in the MMU subforum instea...

In forum Assembly and first prints troubleshooting

6 months ago
Dave: Not sure if this will be helpful, but you are using th...

In forum Hardware, firmware and software help

6 months ago
There was a Prusa video a while ago ( check the blog or YouT...

In forum General discussion, announcements and releases

6 months ago
@igor I have a Mini on order and have a MK3s now. I think o...

In forum General discussion, announcements and releases

6 months ago
No problem. Happy printing!

In forum General discussion, announcements and releases

6 months ago
I previously had a similar situation with PETG. Where the c...

In forum General discussion, announcements and releases

6 months ago
Page 1 / 15
Share:

Please Login or Register