jaydubblazer
jaydubblazer
Group: Registered
Joined: 2019/10/14
Eminent Member
2
For PETG I am currently using 2.4 retraction with a 50mm/s r...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
How small? 5cmx5cm? I would use it to make hand tools and ...

In forum General discussion, announcements and releases

2 months ago
What version of firmware? There was an earlier version that...

In forum Hardware, firmware and software help

2 months ago
@charles-h13 Sorry to bug you again. Any luck with the pc o...

In forum General discussion, announcements and releases

2 months ago
If you just assembled it it might be best to contact Prusa s...

In forum Hardware, firmware and software help

2 months ago
@charles-h13 have you had a chance to try it on the mini yet...

In forum General discussion, announcements and releases

2 months ago
Bondtech Extruder settings for PETG

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
Mine came with zip ties.

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Sorry about that I messed that up. Failure to pay attention...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
it works well until you upgrade to the firmware. It is defi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Yeah finding that out the hard way. Rereading the launch no...

In forum General discussion, announcements and releases

5 months ago
Fan speed 255

In forum Hardware, firmware and software help

5 months ago
Mine did the exact same thing. I thought maybe it was somet...

In forum Hardware, firmware and software help

6 months ago
I agree with assessment and solution. Plastic shouldn’t hav...

In forum Assembly and first prints troubleshooting

6 months ago
Following. I have already disconnected my lcd. Just need t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

7 months ago
Finally got around to replacing the x-axis bearings. It was...

In forum Hardware, firmware and software help

7 months ago
I just forgot to cut the end off my filament and didn't get ...

In forum General discussion, announcements and releases

7 months ago
I just did my 2nd successful filament change. so far so goo...

In forum General discussion, announcements and releases

7 months ago
X axis bearing failure already?

In forum Hardware, firmware and software help

7 months ago
I never had any bed leveling issues, but had to monitor the ...

In forum General discussion, announcements and releases

7 months ago
Page 1 / 2
Share:

Please Login or Register