|
@andrew-d44 I just checked mine. The bottom heat break scre... In forum Assembly and first prints troubleshooting |
4 years ago |
|
@zoltan Hmm, I would hope so, but it seems that the extruder... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Right, so, I have a theory on what the problem is. My printe... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Mine has now very suddenly started doing this with all filam... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Unfortunately as a rotary encoder you'd likely need to short... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Short the pin nearest the bottom left corner onto the body o... In forum Assembly and first prints troubleshooting |
4 years ago |
|
@pingu Mine siezed so hard that after getting through the se... In forum General discussion, announcements and releases |
4 years ago |
|
So I will confirm that G92 can indeed be used to set the "li... In forum General discussion, announcements and releases |
4 years ago |
|
So I've been using a lot of filaments from different brands ... In forum General discussion, announcements and releases |
4 years ago |
|
@gary-s4 Mine's got a red light on the top. It's quite fain... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Ah. Glad to know I'm not alone in this. I've been able to ... In forum General discussion, announcements and releases |
4 years ago |
|
@hforum Which filament are you using? I’ve found that diffe... In forum Hardware, firmware and software help |
4 years ago |
|
@zoltan Yeah man looking good thanks! Before: After: In forum Assembly and first prints troubleshooting |
4 years ago |
|
So I've got to the bottom of it. The grub screws had worked... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Had another look and the Y axis belts seem right; they "ring... In forum Assembly and first prints troubleshooting |
4 years ago |
|
I’ve never had to do that with any other printer. I don’t t... In forum Hardware, firmware and software help |
4 years ago |
|
@zoltan It’s all prints, on the Y axis only. The belt is pr... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Y axis layer shift In forum Assembly and first prints troubleshooting |
4 years ago |
|
Mine does this if the ambient temperature is low. I think i... In forum Assembly and first prints troubleshooting |
4 years ago |
|
Another bug: I fired it up this morning where the ambient te... In forum Hardware, firmware and software help |
4 years ago |
