impression3D.xyz
impression3D.xyz
Group: Registered
Joined: 2020/02/25
Eminent Member
2
upload code to octoprint then print via mk3S SD card instead...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
resell 3d printer kits based on prusa parts

In forum General discussion, announcements and releases

1 month ago
Bonjour je pensais avoir posté dans le forum anglais désol...

In forum Aide concernant le matériel, le firmware ou un logiciel

2 months ago
i bought that i think i will hep to plug the raspberry pi ze...

In forum Aide concernant le matériel, le firmware ou un logiciel

2 months ago
HI, thanks for your answer. jumper wires is a good idea, wit...

In forum Aide concernant le matériel, le firmware ou un logiciel

2 months ago
i followed this guide .. :

In forum Aide concernant le matériel, le firmware ou un logiciel

2 months ago
Raspberry pi zero WH installation

In forum Aide concernant le matériel, le firmware ou un logiciel

2 months ago
hi, thanks for your feedback. i have the prusa PEI sheet wi...

In forum General discussion, announcements and releases

2 months ago
best option for smooth glass first layer

In forum General discussion, announcements and releases

2 months ago
Hi everybody here is some pictures of the first layer with a...

In forum Assembly and first prints troubleshooting

4 months ago
Merci pour ta réponse. J'y ai touché pour voir les impacts,...

In forum Dépannage pour l'assemblage et les premières impressions

4 months ago
Paramètres prusa slicer pour optimiser la première couche

In forum Dépannage pour l'assemblage et les premières impressions

4 months ago
I found the right Z and adjusted flow from 95% to 100% and i...

In forum Assembly and first prints troubleshooting

4 months ago
OK, noted, thanks 🙂

In forum Assembly and first prints troubleshooting

4 months ago
same why 170° in the gcode ? 🙂

In forum Assembly and first prints troubleshooting

4 months ago
same why 170° in the gcode ? 🙂

In forum Assembly and first prints troubleshooting

4 months ago
yes, but i need the bottom layer perfect because some objets...

In forum Assembly and first prints troubleshooting

5 months ago
I sometimes have holes or imperfections like attached pictur...

In forum Assembly and first prints troubleshooting

5 months ago
Hi, i printed a square and playing with live ajust Z to find...

In forum Assembly and first prints troubleshooting

5 months ago
Fist layer finishing and appearance - settings for perfect f...

In forum Assembly and first prints troubleshooting

5 months ago
Page 1 / 2
Share:

Please Login or Register