Activity
 
ian.s3
ian.s3
Group: Registered
Joined: 2016/11/15
Eminent Member
2
Glad to hear it! Yes when a MOSFET fails it normally fails t...

In forum Hardware, firmware and software help

8 months ago
Info on mini rambo is atwhich has schematics. Heater circui...

In forum Hardware, firmware and software help

8 months ago
The X/Y perpendicular and bed levelling are two independent ...

In forum Hardware, firmware and software help

8 months ago
I didn't move the bed, but I did move the PINDA by about 1mm...

In forum Hardware, firmware and software help

9 months ago
I think you are still assuming the offset is due to skew, an...

In forum Hardware, firmware and software help

9 months ago
Thanks for the clarification - yes the nomenclature was what...

In forum Hardware, firmware and software help

9 months ago
My power supply is elsewhere already - I have a remote power...

In forum Hardware, firmware and software help

9 months ago
I don't believe it's attributable to skew - you can get a re...

In forum Hardware, firmware and software help

9 months ago
I think it's reasonably clear that the lost 4mm is "corrects...

In forum Hardware, firmware and software help

9 months ago
No, because the printer thinks it knows where the nozzle is ...

In forum Hardware, firmware and software help

9 months ago
I think it does rely on the PINDA for X positioning during c...

In forum Hardware, firmware and software help

9 months ago
I think maybe Jiri has spotted the same issue but hasn't rea...

In forum Hardware, firmware and software help

9 months ago
So I decided to test this hypothesis, i.e. that the printer ...

In forum Hardware, firmware and software help

10 months ago
Is it? I'm pretty sure my Y-axis microswitch has always bee...

In forum Hardware, firmware and software help

10 months ago
I think you're saying you want the 2.5 extruder, not a 2.5S ...

In forum Hardware, firmware and software help

10 months ago
That doesn't address the fact that the firmware won't move t...

In forum Hardware, firmware and software help

10 months ago
I agree it could in principle do that during the initial cal...

In forum Hardware, firmware and software help

10 months ago
My printer cannot reach the leftmost edge of the printbed, b...

In forum Hardware, firmware and software help

10 months ago
No, that's not the issue. It's not an endstop issue, it's a ...

In forum Hardware, firmware and software help

10 months ago
Have you tried adjusting idler tension? Is the filament gett...

In forum Hardware, firmware and software help

1 year ago
Page 1 / 2
Share:

Please Login or Register