|
Could the Prusa guys publish the files for the motor multipl... In forum Others (Archive) |
7 years ago |
|
Results:
+ Flexible filament feet below standard MK2 feet wi... In forum Improvements (Archive) |
7 years ago |
|
These are fantastic noise dampers. I've tried a number of d... In forum Improvements (Archive) |
7 years ago |
|
Re-post/shameless plug: Vibration dampers! In forum Improvements (Archive) |
7 years ago |
|
Besides the filament guid, which is ingenious, I don't see w... In forum Improvements (Archive) |
8 years ago |
|
Besides the filament guid, which is ingenious, I don't see w... In forum Improvements (Archive) |
8 years ago |
|
I would rather put the printer on small solid board and put ... In forum Improvements (Archive) |
8 years ago |
|
Unfortunately, the frame itself is not firm enough to keep i... In forum Improvements (Archive) |
8 years ago |
|
This is not a good idea. The frame may be crossed/Slant.
In ... In forum Improvements (Archive) |
8 years ago |
|
Printed these little babies earlier today......My god I love... In forum Improvements (Archive) |
8 years ago |
|
Guys, you should definitely try this one out. Whenever I'm j... In forum Improvements (Archive) |
8 years ago |
|
Vibration dampener In forum Improvements (Archive) |
8 years ago |
|
Since it was both on models I've created and on stuff downlo... In forum Others (Archive) |
8 years ago |
|
So if I understand correctly, this is caused during the conv... In forum Others (Archive) |
8 years ago |
|
Higher edge count on circular shapes? In forum Others (Archive) |
8 years ago |
|
New Slic3r can control acceleration "natively", so there is ... In forum Others (Archive) |
8 years ago |
|
No, no, it's not the vibration in general. I actually have ... In forum Others (Archive) |
8 years ago |
|
I've learned that having a messy build table only has disadv... In forum Others (Archive) |
8 years ago |
|
I made a simple build log of my MK2 upgrade! In forum Others (Archive) |
8 years ago |
|
@Nigel I don't think you took my expression to your heart ab... In forum Prusa i3 kit (Archive) |
8 years ago |
