|
You can add a Z movement to the M600 code to give you more v... In forum General discussion, announcements and releases |
4 years ago |
|
I have very limited experience with the textured sheet since... In forum General discussion, announcements and releases |
4 years ago |
|
OK, I figured it out, I think. In forum Improvements (Archive) |
4 years ago |
|
@bobstro Not yet. It would be my first time submitting some... In forum Improvements (Archive) |
4 years ago |
|
Report Long Filename to Octoprint In forum Improvements (Archive) |
4 years ago |
|
As a first step, try cleaning the sensor. There is a hole i... In forum Hardware, firmware and software help |
6 years ago |
|
I was editing at the same time as your post, but the point r... In forum General discussion, announcements and releases |
6 years ago |
|
Wait, what? Why would the indirect sensor need a firmware c... In forum General discussion, announcements and releases |
6 years ago |
|
Does it inevitably first happen on layer 1? That's what I'm... In forum General discussion, announcements and releases |
6 years ago |
|
Bobstro may have been a bit rough in his explanation, but he... In forum General discussion, announcements and releases |
6 years ago |
|
It's often not as bad as it looks. You can heat up the extr... In forum General discussion, announcements and releases |
6 years ago |
|
So, you added a bearing that the filament rides against, and... In forum General discussion, announcements and releases |
6 years ago |
|
So, is the part to clean just under the U1 label on the circ... In forum General discussion, announcements and releases |
6 years ago |
|
Which IP address? From my experience it can cope only with 1... In forum User mods - OctoPrint, enclosures, nozzles, ... |
6 years ago |
|
I don't suppose you checked the crash counter for the print,... In forum General discussion, announcements and releases |
6 years ago |
|
My suggestion is to get the card as close as possible to you... In forum User mods - OctoPrint, enclosures, nozzles, ... |
6 years ago |
|
Where are you located, generally speaking? There may be some... In forum General discussion, announcements and releases |
6 years ago |
|
It turns out that mine was simply dirty. I was getting basi... In forum General discussion, announcements and releases |
6 years ago |
|
I have run through 4 entire spools of transparent filament w... In forum General discussion, announcements and releases |
6 years ago |
|
That smaller cylinder (the cylinder that's missing) on top o... In forum General discussion, announcements and releases |
6 years ago |
