Graham25Fox
Graham25Fox
Group: Registered
Joined: 2019/10/18
Trusted Member
3
Hi can you give me some more info on the heat break, that so...

In forum General discussion, announcements and releases

1 month ago
Thanks for that, i for got to ask if ABS was the same.

In forum General discussion, announcements and releases

1 month ago
while on the subject of petg and rolls is there less length ...

In forum General discussion, announcements and releases

1 month ago
Thanks for that info. The Red petg was brand new , only been...

In forum General discussion, announcements and releases

1 month ago
Translucent red petg going crystaline

In forum General discussion, announcements and releases

1 month ago
Thanks for that i thought it was me, good job i have a few i...

In forum General discussion, announcements and releases

1 month ago
Silicone sock how long do they last?

In forum General discussion, announcements and releases

1 month ago
Just to make it clear, i only turn the part cooling fan off....

In forum General discussion, announcements and releases

2 months ago
Must say i have stopped using IPA, could not get any thing t...

In forum Hardware, firmware and software help

2 months ago
Hi, it is very difficult to fault find, i have the odd squea...

In forum Hardware, firmware and software help

2 months ago
Yes i think no fan is the way yo go, i have had more failed ...

In forum General discussion, announcements and releases

2 months ago
Hi I think you are right about increasing the temp to get st...

In forum General discussion, announcements and releases

2 months ago
Hi cant think what that could be, i use stealth all the time...

In forum General discussion, announcements and releases

2 months ago
@chocki Hi yes i think i will do more printing in PETG, I ha...

In forum General discussion, announcements and releases

2 months ago
@chocki Hi now that is a good tip to know about temp and fin...

In forum General discussion, announcements and releases

2 months ago
Hi i had the same, found it was the wires the wrong way roun...

In forum Assembly and first prints troubleshooting

2 months ago
Hi i tried to put a video up last night, but was not sure if...

In forum Hardware, firmware and software help

2 months ago
For me its mainly the fans that i can hear, quite a lot of t...

In forum Hardware, firmware and software help

2 months ago
Hi i dont know if i have put the video in the right place. i...

In forum Hardware, firmware and software help

2 months ago
Hi, I think the first problem here is just saying "nosisy" d...

In forum Hardware, firmware and software help

2 months ago
Page 1 / 5
Share:

Please Login or Register