|
For me I had to send the whole thing back to Prusa. It's bee... In forum Assembly and first prints troubleshooting |
1 year ago |
|
@robin I am. It was brought to my attention when I started p... In forum Hardware, firmware and software help |
2 years ago |
|
@jsw Yeah the protocol is pretty simple and appears to be si... In forum Hardware, firmware and software help |
2 years ago |
|
@jsw Ah I see the confusion as I didn't fully explain my int... In forum Hardware, firmware and software help |
2 years ago |
|
@robin Thanks. I did see that, but I missed the P1 reference... In forum Hardware, firmware and software help |
2 years ago |
|
@jsw Sorry, it's not obvious to me (I'm a software guy and o... In forum Hardware, firmware and software help |
2 years ago |
|
Wiring diagram for MMU -> Einsy cable? In forum Hardware, firmware and software help |
2 years ago |
|
So I finally appear to have it playing nice again. I ditched... In forum Hardware, firmware and software help |
2 years ago |
|
I'm sorry I never responded to @mitch-3-2, I missed the post... In forum Hardware, firmware and software help |
2 years ago |
|
I can't get it through a first layer calibration as it keeps... In forum Hardware, firmware and software help |
2 years ago |
|
Some problem encountered, z leveling enforced In forum Hardware, firmware and software help |
2 years ago |
|
Press the selector button on the printer and that will start... In forum General discussion, announcements and releases |
2 years ago |
|
Do what? Use PLA as supports for PETG? Because PLA and PETG ... In forum How do I print this? (Printing help) |
2 years ago |
|
Based on today's findings, I don't think it's the path. I th... In forum Hardware, firmware and software help |
2 years ago |
|
So I played with swapping filament paths and filaments aroun... In forum Hardware, firmware and software help |
2 years ago |
|
Nope. Both are using the Prusament PLA profile (and both are... In forum Hardware, firmware and software help |
2 years ago |
|
It shouldn't explicitly need the filament sensor as it's the... In forum General discussion, announcements and releases |
2 years ago |
|
Under extrusion In forum Hardware, firmware and software help |
2 years ago |
|
It's in the printer settings, not the slicer. In forum General discussion, announcements and releases |
2 years ago |
|
You can be honest here. You just needed an excuse to buy the... In forum User mods - OctoPrint, enclosures, nozzles, ... |
2 years ago |
