Activity
 
gnat
gnat
Group: Registered
Joined: 2018/12/03
Prominent Member
2
The biggest issue with multi extruders vs the MMU/Palette is...

In forum General discussion, announcements and releases

3 weeks ago
Sort of, yes. It bed levels, goes to the start point of the ...

In forum Assembly and first prints troubleshooting

4 weeks ago
There is no requirement for X, Y, or Z to be moving while it...

In forum Assembly and first prints troubleshooting

4 weeks ago
Mine does it too. The bubble seemed to show up after PS 2.0 ...

In forum Assembly and first prints troubleshooting

4 weeks ago
Ewww. That seems painfully inefficient and expensive. Seems ...

In forum General discussion, announcements and releases

2 months ago
I might make the areas a little thinner since you have the r...

In forum General discussion, announcements and releases

2 months ago
I think the convenience option is there and configured as su...

In forum General discussion, announcements and releases

2 months ago
Nah this bug has been around since the incredibly bad idea t...

In forum General discussion, announcements and releases

2 months ago
Not sure how well a removable CNC head would be for accuracy...

In forum General discussion, announcements and releases

2 months ago
If it's changing it's reading with you tapping on the tower,...

In forum Assembly and first prints troubleshooting

2 months ago
Double check the plugs on both ends to make sure they are co...

In forum Assembly and first prints troubleshooting

2 months ago
The LED mod for the IR sensor is exceedingly helpful for kno...

In forum Assembly and first prints troubleshooting

2 months ago
PINDA has nothing to do with the filament, it detects being ...

In forum Assembly and first prints troubleshooting

2 months ago
Never used a FlashAir so I can't answer, sorry.

In forum General discussion, announcements and releases

2 months ago
When you reassembled the extruder you likely didn't get the ...

In forum Hardware, firmware and software help

2 months ago
As already said, disconnect the data or power for the MMU an...

In forum How do I print this? (Printing help)

2 months ago
Actually you could have it do the mesh leveling and then add...

In forum General discussion, announcements and releases

2 months ago
Apologies again for getting side tracked and missing the iss...

In forum Assembly and first prints troubleshooting

2 months ago
You can't simply print parts to upgrade to the 3S as the fil...

In forum Assembly and first prints troubleshooting

2 months ago
In my case I found it first when I did the S upgrade. There ...

In forum General discussion, announcements and releases

2 months ago
Page 1 / 39
Share:

Please Login or Register