GkMakeIt
GkMakeIt
Group: Registered
Joined: 2019/01/31
Estimable Member
4
@epl Awesome!

In forum How do I print this? (Printing help)

2 days ago
Try raising your first layer Z up around .075mm (away from t...

In forum How do I print this? (Printing help)

2 days ago
I would recommend uploading some pictures, good vs bad if yo...

In forum Assembly and first prints troubleshooting

4 days ago
When doing the X calibration does it look like the head goes...

In forum Assembly and first prints troubleshooting

6 days ago
For a quick fix you can use the "variable layer height" opti...

In forum How do I print this? (Printing help)

2 weeks ago
@ssmith Glad you hear you're making progress. Looking at th...

In forum Assembly and first prints troubleshooting

2 weeks ago
@mj-caboose Did you check it both when it was at room temper...

In forum Assembly and first prints troubleshooting

3 weeks ago
I've never had a PLA that had to run so hot, sounds more lik...

In forum Assembly and first prints troubleshooting

3 weeks ago
What well know brand are you talking about? Atomic Filament...

In forum Assembly and first prints troubleshooting

3 weeks ago
It's starting to feel like it's that filament. Have you done...

In forum Assembly and first prints troubleshooting

3 weeks ago
Do you have a way to check the diameter of the filament? Doe...

In forum Assembly and first prints troubleshooting

3 weeks ago
You want to do this after you've let the heat bed get up to ...

In forum Assembly and first prints troubleshooting

3 weeks ago
I would guess it's an uneven (not flat) print surface if it'...

In forum How do I print this? (Printing help)

3 weeks ago
Hey, Wash your build plate with the hottest water you can ge...

In forum How do I print this? (Printing help)

3 weeks ago
Your first layer Z calibration number can vary quite a bit a...

In forum Assembly and first prints troubleshooting

3 weeks ago
Let's see how well the filament flows out of your nozzle. Ma...

In forum Assembly and first prints troubleshooting

3 weeks ago
The top of the first layer, is it smooth or bumpy? Theres...

In forum Assembly and first prints troubleshooting

4 weeks ago
@muller-stephane Let's take a closer look at the first layer...

In forum Assembly and first prints troubleshooting

4 weeks ago
@muller-stephane Nope. On the printer display navigate to th...

In forum Assembly and first prints troubleshooting

4 weeks ago
@muller-stephane After you completed the rebuild did you run...

In forum Assembly and first prints troubleshooting

4 weeks ago
Page 1 / 9
Share:

Please Login or Register