Activity
 
gdo
gdo
Group: Moderator
Joined: 2017/11/04
Title: Member Moderator
2
After receiving my powder coated sheet recently, I had a pre...

In forum General discussion, announcements and releases

1 year ago
Cleaning up here after joan.t – I removed the most recent po...

In forum General discussion, announcements and releases

2 years ago
Yes, it would appear that an activated charcoal filter indee...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Hi, kleiner Nachtrag. Habe meine Platte wohl zu oft abgerieb...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

2 years ago
I set the extra length on restart to -.02mm. The near-perfec...

In forum Others (Archive)

2 years ago
While Prusa's shipping options aren't cheap, I don't think t...

In forum General discussion, announcements and releases

2 years ago
Hast du die Druckunterlage vor dem Druck stets mit Propanol ...

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

2 years ago
Joan, No, it doesn't seem to be possible at this time. Ther...

In forum General discussion, announcements and releases

2 years ago
Is it just photo distortion, or does the Y motor look like i...

In forum Assembly and first prints troubleshooting

2 years ago
This is an older post, but I just want to say thank you, bec...

In forum Others (Archive)

2 years ago
Your observation is correct - the cost estimate only appears...

In forum Hardware, firmware and software help

2 years ago
I sometimes see extrusion problems once a fresh filament spo...

In forum Hardware, firmware and software help

2 years ago
Did you check that the X axis can move freely? I had a simil...

In forum Assembly and first prints troubleshooting

2 years ago
In many cases, I find it easier to add specific support stru...

In forum How do I print this? (Printing help)

2 years ago
Ha, using squash balls as dampers is very clever indeed! 😀

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Have you ried running the z axis up to the top. To ballance ...

In forum Others (Archive)

2 years ago
your a god send I used these settings and my Petg problems ...

In forum Others (Archive)

2 years ago
Page 1 / 2
Share:

Please Login or Register