FransKrau
FransKrau
Group: Registered
Joined: 2017/01/12
Trusted Member
3
Hi, I have upgraded two MK2s with magnets and made my own st...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Hi, I have upgraded two MK2s with magnets and made my own st...

In forum Hardware, firmware and software help

2 months ago
For me number 1 is Fusion 360, and sometimes Tinkercad, beca...

In forum General discussion, announcements and releases

4 months ago
Hi, just search in this forum for Z level adjustment first...

In forum General discussion, announcements and releases

4 months ago
Upgrade for my MK2S, and still happy

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 months ago
I was quit curious about your issue, so I tested my m2 right...

In forum Hardware, firmware and software help

5 months ago
Hi Sean, The message Bed Thermal Runaway, indicades that t...

In forum Hardware, firmware and software help

5 months ago
If I place your cube on the bed of PS as presented in your s...

In forum PrusaSlicer

8 months ago
Hi Edward, I had the same issue. I found a thread in this fo...

In forum PrusaSlicer

8 months ago
I had issue like that. It was solved when I wait with printi...

In forum Hardware, firmware and software help

1 year ago
Your write: I tried to recalibrate it but I've got an error ...

In forum General discussion, announcements and releases

1 year ago
1. After a print my printhead goes +50mm up so non influence...

In forum Hardware, firmware and software help

1 year ago
I modified my MK2s with rare magnets under the PCB, removed ...

In forum Hardware, firmware and software help

1 year ago
oh jeah and the price somewhere around € 50 Frans

In forum General discussion, announcements and releases

2 years ago
Hi Mark, by hart (I am not at home) 6 Rods (harder surface...

In forum General discussion, announcements and releases

2 years ago
To understand your problem, I think you mean that the mesh b...

In forum Hardware, firmware and software help

2 years ago
For the start: you have done the full calibration (XYZ), inc...

In forum Hardware, firmware and software help

2 years ago
Hi, not an answer to your question, but just a question to u...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Could be that the wire of the PINDA is just to be broken (on...

In forum Hardware, firmware and software help

2 years ago
What is your setting for seam? Frans

In forum How do I print this? (Printing help)

2 years ago
Page 1 / 4
Share:

Please Login or Register