fheatherz
fheatherz
Group: Registered
Joined: 2019/07/17
Eminent Member
2
I have had this twice, unfortunately. First time Prusa suppo...

In forum Assembly and first prints troubleshooting

1 week ago
I changed my part fan to a Sunon, which is noisier but pushe...

In forum How do I print this? (Printing help)

2 months ago
QSM-m5 in the US?

In forum Hardware, firmware and software help

2 months ago
Those are only for the MMU2s, so probably would not show up ...

In forum Hardware, firmware and software help

6 months ago
I ordered one labeled "qsm-m5-4" on amazon and there was no ...

In forum Hardware, firmware and software help

6 months ago
Hi! I am in the US too and could not find the exact match an...

In forum Hardware, firmware and software help

6 months ago
Another person using the buffer here - I did add the mod for...

In forum General discussion, announcements and releases

6 months ago
Mine is the same way. I was using a different cable for a PC...

In forum Assembly and first prints troubleshooting

7 months ago
@robert-rmm200 that makes sense - my connectors were not loo...

In forum Assembly and first prints troubleshooting

7 months ago
I just had this exact thing happen - same issue, angled conn...

In forum Assembly and first prints troubleshooting

7 months ago
Yes, there should be lights and lots of loud clacking noises...

In forum Assembly and first prints troubleshooting

7 months ago
I used both Orange and black SunLu right out of the vacuum s...

In forum General discussion, announcements and releases

7 months ago
I could not get SunLu to stick for anything, finally returne...

In forum General discussion, announcements and releases

7 months ago
I haven't had too many problems with mine although I usually...

In forum Hardware, firmware and software help

7 months ago
@ryan-f15 Yowsa! I would clean the bed if not done already a...

In forum General discussion, announcements and releases

7 months ago
@fred I have done it, didn't grease on install. It's not tha...

In forum General discussion, announcements and releases

8 months ago
@tim-m30 I'll try that.. Not even sure the filament sensor i...

In forum Hardware, firmware and software help

9 months ago
@vintagepc I actually tried that - just instinct to press th...

In forum Hardware, firmware and software help

9 months ago
Just had this exact same problem. Printer just stopped in th...

In forum Hardware, firmware and software help

9 months ago
I print TPU all the time on my creality (bowden), no problem...

In forum Hardware, firmware and software help

10 months ago
Page 1 / 2
Share:

Please Login or Register