encity5
encity5
Group: Registered
Joined: 2020/05/11
Active Member
1
I think i was in a similar situation. finally deciding on th...

In forum General discussion, announcements and releases

3 months ago
@peter-m26 Thanks!, Prusa's youtube video on changing a nozz...

In forum Assembly and first prints troubleshooting

4 months ago
@bobstro I've been using your startup gcode for the past few...

In forum Assembly and first prints troubleshooting

4 months ago
well on closer inspection, after cleaning the nozzle and hea...

In forum Assembly and first prints troubleshooting

4 months ago
filament blobbing and falling from nozzle ruining prints

In forum Assembly and first prints troubleshooting

4 months ago
beginner question: Procedure for start of prints?

In forum Assembly and first prints troubleshooting

4 months ago
some updates: tried the brass rod, heated nozzle, took it of...

In forum Assembly and first prints troubleshooting

4 months ago
@kishkov same issue? another clog? 🙁

In forum Assembly and first prints troubleshooting

4 months ago
@kishkov thanks! havent managed to fix it yet, getting over ...

In forum Assembly and first prints troubleshooting

4 months ago
@bobstro I tried pushing and pulling by heating the nozzle t...

In forum Assembly and first prints troubleshooting

4 months ago
Talking to support tried a few things. raised the temp to 28...

In forum Assembly and first prints troubleshooting

4 months ago
clicking noise, filament stuck

In forum Assembly and first prints troubleshooting

4 months ago
shipped yesterday, arrived this morning. if i realized shipp...

In forum General discussion, announcements and releases

4 months ago
Finally! my turn came up, and got the shipping confirmation....

In forum General discussion, announcements and releases

4 months ago
Ordered mine 05/05, nothing yet 😭

In forum General discussion, announcements and releases

5 months ago
Share:

Please Login or Register