Notifications
Clear all
Emanuele I
Emanuele I
Group: Registered
Joined: 2018/01/07
Active Member
1
This is the final result:

In forum How do I print this? (Printing help)

1 year ago
I solved the problem simply optimizing the number of perimet...

In forum How do I print this? (Printing help)

1 year ago
Thank you for your suggestion @fuchsr, but switching to clas...

In forum How do I print this? (Printing help)

1 year ago
Rough walls - probably incorrect wall thickness

In forum How do I print this? (Printing help)

1 year ago
Yesterday I had this problem again. So I unplugged all wirin...

In forum Hardware, firmware and software help

4 years ago
Hi, I've used dimafix on the latest 3 prints on my smooth PE...

In forum Others (Archive)

4 years ago
Hi Andarne. I also suspect the problem might be related to p...

In forum Hardware, firmware and software help

4 years ago
PSU: Silver stock Firmware: MMU2S v 1.0.6-372 - MK3S v 3.8.0...

In forum Hardware, firmware and software help

4 years ago
I think this is the same problem described here: I had the ...

In forum Hardware, firmware and software help

4 years ago
My hypothesis seems to be confirmed also by the Prusa guide ...

In forum Assembly and first prints troubleshooting

5 years ago
Front PTFE holder assembly and tubes orientation: are we sur...

In forum Assembly and first prints troubleshooting

5 years ago
Inches: 10 7/8"W x 9 3/8"D (screws stick out 5/8 so real mea...

In forum General discussion, announcements and releases

5 years ago
Hi @richard.p16, could you please post the rough measurement...

In forum General discussion, announcements and releases

5 years ago
Share: