dwisejr
dwisejr
Group: Registered
Joined: 2019/11/28
Eminent Member
2
It worked pretty good for the last week and a half. But last...

In forum Hardware, firmware and software help

2 months ago
Thank you very much for the reply and guidance. My first lay...

In forum Hardware, firmware and software help

3 months ago
I can't remember, or find record of, where I got that filame...

In forum Hardware, firmware and software help

3 months ago
I think it's OK now. I did the bed leveling and first layer ...

In forum Hardware, firmware and software help

3 months ago
I backed the heat sink out just a hair and it now quickly re...

In forum Hardware, firmware and software help

3 months ago
We have a 3D printing department where I work. I talked to t...

In forum Hardware, firmware and software help

3 months ago
Thank you for the reply and assistance. I am confused beca...

In forum Hardware, firmware and software help

3 months ago
I got it apart and cleaned out again, and reassembled. But n...

In forum Hardware, firmware and software help

3 months ago
Thanks for the reply. That was the only way I could figure ...

In forum Hardware, firmware and software help

3 months ago
I got it out. Filament was stuck at the bottom of the hot en...

In forum Hardware, firmware and software help

3 months ago
Thank you for the reply. There are no chew marks on the fila...

In forum Hardware, firmware and software help

3 months ago
Extruder not pulling filament

In forum Hardware, firmware and software help

3 months ago
The oil seems to have done the trick. After two long failed ...

In forum How do I print this? (Printing help)

3 months ago
Thank you so much. I'm noting all of this.

In forum How do I print this? (Printing help)

3 months ago
Thank you so very much! I will try the oil right away. And I...

In forum How do I print this? (Printing help)

3 months ago
I printed the 8 inch tea cup in the attached photo with no t...

In forum How do I print this? (Printing help)

3 months ago
@tim-m30 Thank you for the reply. I found the settings. X = ...

In forum How do I print this? (Printing help)

3 months ago
I printed a small version of this Scrooge bust, but larger o...

In forum How do I print this? (Printing help)

3 months ago
I found it. Thank you very much!

In forum How do I print this? (Printing help)

3 months ago
Thank you! Do I need to add the supports in the drawing, or ...

In forum How do I print this? (Printing help)

3 months ago
Page 1 / 2
Share:

Please Login or Register