Activity
 
Notifications
Clear all
Durahl
Durahl
Group: Registered
Joined: 2019/07/20
Estimable Member
4
So far, I've found that ABS works without issues in ASA - Af...

In forum General discussion, announcements and releases

6 months ago
Viva La Bronze as ASA?

In forum General discussion, announcements and releases

6 months ago
Yea... I kinda stepped up my 3D Printing Game after I got my...

In forum Awesome prints (Hall Of Fame)

2 years ago
Well......would pretty much be a prime example of how a comp...

In forum General discussion, announcements and releases

2 years ago
A bit longer 😉 Length of the Chassis is 570mm for a total of...

In forum Awesome prints (Hall Of Fame)

2 years ago
3D printed E-100 ( with Maus Turret )

In forum Awesome prints (Hall Of Fame)

2 years ago
Thanks for the reply! My currently used springs appear to be...

In forum General discussion, announcements and releases

2 years ago
Any insights on the working principle of Compression Springs...

In forum General discussion, announcements and releases

2 years ago
Yea... As I wasn't able to get hold of the recommended Prime...

In forum General discussion, announcements and releases

2 years ago
Where do you get your Rust-Oleum from in the EU? Amazon does...

In forum General discussion, announcements and releases

2 years ago
Surface Primer for getting rid of ASA Layer Lines?

In forum General discussion, announcements and releases

2 years ago
I didn't even know elephants' foot was a thing to begin with...

In forum Awesome prints (Hall Of Fame)

2 years ago
Can someone point me into the direction of where one can get...

In forum General discussion, announcements and releases

2 years ago
Mhh... I'd argue that your question kinda depends on the siz...

In forum General discussion, announcements and releases

2 years ago
Personally, I'd welcome the addition of a ruler to the paint...

In forum PrusaSlicer

2 years ago
In the Release Candidate you can also "fix" this by simply c...

In forum PrusaSlicer

2 years ago
Correcting Time Estimates?

In forum PrusaSlicer

2 years ago
There's not much I can do about raising the temps in that en...

In forum How do I print this? (Printing help)

3 years ago
Sure did, the spool has been permanently residing in an eSUN...

In forum How do I print this? (Printing help)

3 years ago
"Fungi" and "Blobs" on otherwise perfect surface prints

In forum How do I print this? (Printing help)

3 years ago
Page 1 / 6
Share: