|
I'm very impressed. I printed this Benchy with PETG and a 0,... In forum Input Shaper (MINI) |
7 months ago |
|
just some ideas: - using the right settings in Prusaslicer i... In forum Assembly and first prints troubleshooting |
4 years ago |
|
I started with PLA on my Mini some month ago. The adhesion t... In forum General discussion, announcements and releases |
4 years ago |
|
Counter In forum Hardware, firmware and software help |
4 years ago |
|
For me, the subject of the annoying beeping is finished. My... In forum General discussion, announcements and releases |
4 years ago |
|
@tm4n I switched from PLA to PETG now, and I can say it does... In forum General discussion, announcements and releases |
4 years ago |
|
@jweaver I support the "noise issue" on Github. It's basical... In forum General discussion, announcements and releases |
4 years ago |
|
@hawwwran There are also some discussions/reports concerning... In forum Hardware, firmware and software help |
4 years ago |
|
@hawwwran yes, same here. After 20 to 30 mins it getting hot... In forum General discussion, announcements and releases |
4 years ago |
|
@crawlerin okay, makes sense to me, I will give it a try. In forum General discussion, announcements and releases |
4 years ago |
|
@jbolene42 I tried your approach to rename the stick, but it... In forum Hardware, firmware and software help |
4 years ago |
|
@bobstro what's the reason behind to use this paver stone? M... In forum General discussion, announcements and releases |
4 years ago |
|
@mitcan now it also happens to me: USB is not detected. I ne... In forum Hardware, firmware and software help |
4 years ago |
|
After some days of printing with my Mini, I can say it's abs... In forum General discussion, announcements and releases |
4 years ago |
|
I ordered with filament sensor. In forum General discussion, announcements and releases |
4 years ago |
|
My Mini arrived today. Unboxing, assembling, printing, prin... In forum General discussion, announcements and releases |
4 years ago |
|
I received the shipment-notification today. 😆 Spreadsheet i... In forum General discussion, announcements and releases |
4 years ago |
|
my delivery week is coming closer (next week). Hopefully the... In forum General discussion, announcements and releases |
4 years ago |
|
@matteo-cristini Congratulations. 😉 Finally you made it. I n... In forum General discussion, announcements and releases |
4 years ago |
|
@hawwwran hey you're all lucky guys. I ordered also on the 1... In forum General discussion, announcements and releases |
4 years ago |
