Activity
 
Notifications
Clear all
DrGary
DrGary
Group: Registered
Joined: 2017/09/25
Active Member
1
Thanks, tim-m30. I'm guessing it's not warp because the part...

In forum Hardware, firmware and software help

4 years ago
[Correction: It's PrusaSlicer v2.1.0+]

In forum Hardware, firmware and software help

4 years ago
Y axis layer shifts caused by hot end hitting the print

In forum Hardware, firmware and software help

5 years ago
Thanks, tim-m30. Super helpful to see the different types of...

In forum Hardware, firmware and software help

5 years ago
What is a layer-shift, physically?

In forum Hardware, firmware and software help

5 years ago
Thanks, rob.l6, aaron.s5, and nikolai.r. Sounds like a lot ...

In forum Print tips (Archive)

6 years ago
Tests that actually determine settings?

In forum Print tips (Archive)

6 years ago
You may want to check the custom bounding box and then set s...

In forum Others (Archive)

6 years ago
Octoprint can't monitor SD Card prints

In forum Others (Archive)

6 years ago
Ok, so attached is some gcode that fails every time with an ...

In forum Others (Archive)

6 years ago
Yes, I'm seeing the same error consistently on two different...

In forum Others (Archive)

6 years ago
I realized I could answer this question precisely by looking...

In forum Others (Archive)

6 years ago
How does M115 work?

In forum Others (Archive)

6 years ago
Looking on Amazon, I found these side-opening sleeves: 1/...

In forum Others (Archive)

6 years ago
Why heat the bed after first few layers?

In forum Print tips (Archive)

6 years ago
Printing speed vs quality

In forum Others (Archive)

6 years ago
Share: