Activity
 
Notifications
Clear all
Dreide
Dreide
Group: Registered
Joined: 2018/01/03
Trusted Member
3
Somewhat off-topic, but remember that you already have a pre...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Note that the PWM control of the fan switches GND, not +5V. ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Wenn ich das Teil drucken müßte, würde ich es wahrscheinlich...

In forum Hilfe zur Hardware, Firmware und Software

5 years ago
Ah., sorry. Sehe gerade, daß du vermutlich das andere Teil m...

In forum Hilfe zur Hardware, Firmware und Software

5 years ago
Drucken? Modelle bei Thingiverse, "E3D Bowden Clip".

In forum Hilfe zur Hardware, Firmware und Software

5 years ago
Now including a tower done with constant extruder linearity ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
There is no contest at all. The Moons 0.9 on the extruder bl...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Still running the Moons MS17HA2P4100 0.9º OK on extruder.......

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
I found reading around that the Rambo is limited to about 10...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Is this no name motor built like cr*p or usable? Will it pro...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
As far as the overheating problem is concerned, I am afraid ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
MS17HA2P4100 is an even better match by spec. A pair of them...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Probably should boost the x axis homing a little. X-axis doe...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
That is a lot less hysteresis than the stock motors. Because...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
What we're trying to correct are position errors, not torque...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Very puzzling - but at the end of the section, it has a note...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
After some digging, I believe that for a 2 phase stepper the...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
I have been trying to get a modified sin^power working in a ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
If the EINSY is indeed unable to keep up in standard mode wi...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
I get 16 VFA's/ cm in the prints. Stepper is 200 cycles / r...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years ago
Page 1 / 4
Share: