Activity
 
Notifications
Clear all
Diem
Diem
Group: Registered
Joined: 2017/12/27
Illustrious Member
Cheerio,

In forum General discussion, announcements and releases

2 days ago
Don't use a wipe tower, wipe into fill, or a wipe object, in...

In forum General discussion, announcements and releases

2 days ago
As the filament turns a corner it drags some of the previous...

In forum How do I print this? (Printing help)

2 days ago
And many users never update firmware (or slicers) until they...

In forum General software discussion

3 days ago
Wouldn't the plate type in the filename be enough memory jog...

In forum Hardware, firmware and software help

4 days ago
Is this 1.5mm OD? A 0.4mm nozzle extrudes 0.45mm wide by def...

In forum PrusaSlicer

4 days ago
Incompatible filaments that do not 'grab' each other need to...

In forum General discussion, announcements and releases

4 days ago
The Original Prusa XL can print true multi-material prints w...

In forum General discussion, announcements and releases

4 days ago
It doesn't matter to the printer ... but you could simply in...

In forum Hardware, firmware and software help

4 days ago
Splitting questions: would it be possible to have a tiny...

In forum General discussion, announcements and releases

4 days ago
This question comes up about once every month. If you searc...

In forum General discussion, announcements and releases

4 days ago
Interesting, the first time I have player with the feature, ...

In forum Hardware, firmware and software help

4 days ago
Never assume new filament is dry. The worst thing that ma...

In forum Hardware, firmware and software help

5 days ago
There are several config options available at the command li...

In forum PrusaSlicer

6 days ago
Or print it on adhesive label paper and stick it on. Cheerio...

In forum How do I print this? (Printing help)

6 days ago
Probably not. Take care not to touch anything hot: Open the ...

In forum Hardware, firmware and software help

6 days ago
The goal is to print this item exactly as it appears below a...

In forum PrusaSlicer

6 days ago
Rather than modifying the printer cut the model in half vert...

In forum General discussion, announcements and releases

6 days ago
And filament does not get wet in 9 hours. Sometimes it's les...

In forum Hardware, firmware and software help

6 days ago
It's hard to tell from the picture - do you have overhangs o...

In forum How do I print this? (Printing help)

6 days ago
Page 1 / 262
Share: